Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)

• A.copy running-config startup-config
• B.copy running-config checkpoint boot-config
• C.save
• D.copy config config1 config startup-config
• E.write memory

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?

• A.Access-2# configure
  Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
• B.Access-2# configure
  Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
• C.Access-2# configure
  Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
• D.Access-2# configure
  Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What change on Core-1 will result in a successful ping to 10.1.1.254 from the management interface?

• A.Change the Core-1 management address to 10.1.1.1/25 first
• B.The destination 10.1.1.254 requires configuring a static route
• C.Use the command ping 10.1.1.254 vrf mgmt
• D.Use the command ping 10.1.1.254/24

Comment: *

Name: *

Email: *

Verification: *

Which two port characteristics must match between LAG interfaces? (Choose two.)

• A.Media type
• B.Member ID
• C.Port number
• D.Chassis number
• E.Duplex

Comment: *

Name: *

Email: *

Verification: *

You have completed a successful VSF stack between two switches.
Without manually assigning a backup switch, what is the expected output when issuing a show vsf command?

• A.Option C
• B.Option A
• C.Option D
• D.Option B

Comment: *

Name: *

Email: *

Verification: *