A junior network engineer is studying for a certification and needs to understand how a router makes a forwarding decision when it has multiple routes to the same destination network.
Consider the following entries in a routing table:
S > 0.0.0.0/0 [1/0] via 10.1.1.1
O > 172.16.0.0/16 [110/20] via 10.2.2.2
S > 172.16.10.0/24 [1/0] via 10.3.3.3
If the router receives a packet with a destination IP address of 172.16.10.5, which route will it use?

• A.The router will load balance the traffic between the OSPF and the static route.
• B.The OSPF route to 172.16.0.0/16 because OSPF is a dynamic protocol.
• C.The default route to 0.0.0.0/0 because it has the lowest administrative distance.
• D.The static route to 172.16.10.0/24 because it is the most specific match.

Comment: *

Name: *

Email: *

Verification: *

What is the method for setting up an HPE Aruba Networking CX 8100 switch using an Android device, and which is recommended for ease of use?

• A.Connect the USB Bluetooth adapter to the switch's USB-C port.
• B.Connect the USB Bluetooth adapter to the switch's USB-A port.
• C.Connect the Android phone to the switch's USB-C port.
• D.Connect the Android phone to the switch management port using the RJ-45 adapter.

Comment: *

Name: *

Email: *

Verification: *

Refer to the diagram below.

After a recent network change, the helpdesk reports that some users could not connect to the print server, Server-1, which is in VLAN 20. After further investigation, you find that only devices directly connected to Access-2 are affected.
Which part of the network should you investigate?

• A.The configured VLAN on Access-2 port 1/1/4.
• B.The link status of Access-2 port 1/1/28.
• C.Subnet mask on clients connected to Access-2.
• D.Allowed VLANs between access switches.

Comment: *

Name: *

Email: *

Verification: *

A Network Operator is examining the MAC address table of a switch to troubleshoot a connectivity issue.
show mac-address-table vlan 10
MAC Address Port Type
-- -
00:50:56:8d:1a:2b 1/1/1 Dynamic
00:50:56:8d:3c:4d 1/1/1 Dynamic
00:50:56:8d:5e:6f 1/1/2 Dynamic
How does a Layer 2 switch build this table?

• A.By downloading the table from the default gateway via ARP.
• B.By inspecting the destination MAC address of incoming frames.
• C.By inspecting the source MAC address of incoming frames.
• D.By receiving broadcast announcements from a central MAC address server.

Comment: *

Name: *

Email: *

Verification: *

A technician installed a new HPE Aruba Networking 580EX Series access point, which is cabled back to an HPE Aruba Networking CX 6000 48G 4SFP switch. However, there are no lights on the access point.
What could cause this issue?

• A.The wrong VLAN has been configured.
• B.The switch does not have enough PoE budget per port.
• C.STP has not been configured.
• D.The access point cannot connect to HPE Aruba Networking Central.

Comment: *

Name: *

Email: *

Verification: *