Question 96
A junior network engineer needs to configure a network interface with the IP address 10.1.1.1 and a subnet mask of 255.255.255.0.
Which of the following are valid ways to express this configuration on an HPE Aruba Networking CX switch? (Select all that apply.)
Question 97
A network engineer configures VLAN 10 for Finance and VLAN 20 for Human Resources. By default, what is true about communication between these VLANs?
Question 98
What describes the use of the Network Analytics Engine?
Question 99
A Junior Network Engineer needs to transfer a new firmware file to an HPE Aruba Networking CX switch. The primary requirement is that the transfer must be secure and encrypted. Which network management protocol should be used for this task?
Question 100
A Security Analyst is using a network sniffer to analyze a traffic capture. They are looking at a frame that was just received by a switch from a host.
[Ethernet II Header]
Destination MAC: 00:1b:77:54:7d:f0
Source MAC: 00:1b:77:54:7d:f1
EtherType: IPv4 (0x0800)
[IP Header]
Source IP: 192.168.1.10
Destination IP: 192.168.1.20
[TCP Header]
Source Port: 49152
Destination Port: 443
Which OSI model layer is primarily responsible for the information contained within the Ethernet II header?