Which statement is true given the IP address 10.64.0.240 and subnet mask 255.255.254.0?

• A.10.64.0.240 is a broadcast address.
• B.There are more than 8 bits in the host portion.
• C.The network portion of the address is 10.64.
• D.The prefix length of the network is /25.

Comment: *

Name: *

Email: *

Verification: *

In order for the ZTP process to succeed, which of the following are required?

• A.A DHCP server with options 5, 23, and 67
• B.HPE Aruba Networking Central
• C.A DHCP server with options 43, 66, and 67
• D.The HTTP Proxy Location

Comment: *

Name: *

Email: *

Verification: *

A retail store chain customer is replacing 1,496 AOS-S switches with HPE Aruba Networking CX 6000 switches. The customer is interested in using ZTP to provision the new switches. However, they are concerned about when the switch starts the ZTP process and whether ZTP may change configurations on switches that are already deployed.
What would address this concern?

• A.If the ZTP operation detects that the DHCP option provided by the TFTP server already has the switch serial number assigned as a configuration file, the ZTP operation ends.
• B.If the ZTP operation detects that the switch has already been added to HPE Aruba Networking Central, the ZTP operation ends.
• C.If the ZTP operation detects that ztp force-provisioning is set, software and configuration are automatically deployed, and the ZTP operation starts.
• D.If the ZTP operation detects that the switch configuration is different from the factory-default configuration, the ZTP operation ends.

Comment: *

Name: *

Email: *

Verification: *

Which HPE Aruba Networking tool would help you visualize a network path between a virtual server and switch port?

• A.HPE Aruba Networking Fabric Composer
• B.HPE Aruba Networking Central
• C.HPE Aruba Networking Central On-Prem
• D.Network Analytics Engine

Comment: *

Name: *

Email: *

Verification: *

A Junior Network Engineer is tasked with increasing the uplink bandwidth and providing redundancy between a new access layer switch (ALS) and a core switch. The engineer decides to configure a Link Aggregation Group (LAG) using two 10Gbps ports (1/1/47 and 1/1/48) on the ALS. The LAG should be configured to use LACP for dynamic negotiation.
Initial State:
* Ports 1/1/47 and 1/1/48 are physically connected to the core switch.
* The core switch is already configured to use LACP on its corresponding ports.
* The required VLANs are already created on the switch.
Required Configuration:
* Create a Link Aggregation Group numbered 2.
* Configure the LAG to operate in active LACP mode.
* Add physical interfaces 1/1/47 and 1/1/48 as members of LAG 2.
* Enable the LAG interface.
Which of the following configuration sets correctly implements the specified LACP LAG?

• A.interface lag 2
  no shutdown
  lacp mode active
  ports 1/1/47, 1/1/48
• B.interface 1/1/47-1/1/48
  no shutdown
  lag 2
  interface lag 2
  lacp mode active
• C.interface 1/1/47-1/1/48
  lacp group 2 mode active
  interface lag 2
  no shutdown
• D.interface lag 2
  no shutdown
  lacp mode active
  interface 1/1/47
  lag 2
  interface 1/1/48
  lag 2

Comment: *

Name: *

Email: *

Verification: *