A Network Operator is troubleshooting a user's report of being unable to access a specific external website, `corp.example.com`. The operator can successfully ping the website's IP address (198.51.100.10) from the user's gateway switch, confirming basic Layer 3 reachability.
The operator now suspects a DNS resolution issue.
The operator needs a command that will:
1. Use the switch's configured DNS servers.
2. Attempt to resolve the hostname `corp.example.com` to an IP address.
3. Display the resulting IP address if successful.
Which of the following commands is the correct tool to perform this DNS validation task directly from the switch?

• A.`traceroute corp.example.com`
• B.`show hosts`
• C.`ping corp.example.com`
• D.`show dns client`

Comment: *

Name: *

Email: *

Verification: *

You have recently configured a LAG interface between two HPE Aruba Networking CX switches. You have noticed congestion on one of the links and very little traffic on the other.
Based on the following output, what should you configure to reduce the congestion?
switch# show lacp aggregates lag10
Aggregate-name : lag10
Aggregated-interfaces : 1/1/1 1/1/2
Heartbeat rate : Slow
Hash : l3-src-dst
Aggregate mode : passive

• A.Change the hash algorithm.
• B.Change the LACP mode.
• C.Configure a static LAG.
• D.Configure LACP fast rate.

Comment: *

Name: *

Email: *

Verification: *

A Network Technician is observing a high number of late collisions and CRC errors on a switch port that is connected to an older hub. The port is configured for auto-negotiation. What Layer 1 issue is the most likely cause of these errors?

• A.The switch port and the hub are operating in full-duplex mode.
• B.The cable connecting the switch and the hub is too short.
• C.The switch port has negotiated to full-duplex, while the hub can only operate in half-duplex.
• D.The switch port has negotiated to a higher speed than the hub can support.

Comment: *

Name: *

Email: *

Verification: *

A customer has a requirement for a Layer 2 stacked solution. The solution below is what is being proposed:
- 2x CX 6200F 24p
- 2x CX 6300M 24p
What would be a differentiator between the offered switch families?

• A.The CX 6300M has more SFP ports than the CX 6200F.
• B.The CX 6300M has higher port speeds for stacking.
• C.The CX 6200F has a modular design with hotswappable power supplies.
• D.The CX 6200F has more ports for stacking.

Comment: *

Name: *

Email: *

Verification: *

Based on the given output:

Which HPE Aruba Networking CX switch can be used to create this configuration?

• A.CX 8320
• B.CX 6400
• C.CX 6300
• D.CX 6000

Comment: *

Name: *

Email: *

Verification: *