A router's IP routing table has an entry with a next-hop IP address of 10.30.233.1.
What does this number represent?

• A.The packet destination.
• B.The cached ARP entry for the destination MAC address.
• C.The next Layer 3 device that should receive the packet.
• D.The router's own egress interface for routing.
• E.The next Layer 2 switch that should receive the packet.

Comment: *

Name: *

Email: *

Verification: *

A Solutions Architect is designing the physical infrastructure for a new office building. The design requires horizontal cable runs from wiring closets to user desks, with a maximum length of 90 meters. The network must support 1Gbps connectivity for all users today, with the potential to upgrade to 5Gbps in the future using the same cabling.
Which is the most appropriate and future-proof type of copper cabling to install?

• A.Cat6
• B.Cat6a
• C.Cat7
• D.Cat5e

Comment: *

Name: *

Email: *

Verification: *

A Solutions Architect is conducting a final validation of a newly installed core switch. The architect needs to quickly get a high-level summary of the switch's health and resources. Which troubleshooting commands would provide a good "dashboard" view of the switch's overall health?
(Select all that apply.)

• A.`show running-config`
• B.`show system resource-utilization`
• C.`show system`
• D.`show mac-address-table`
• E.`show logging -r`

Comment: *

Name: *

Email: *

Verification: *

A Network Administrator is troubleshooting an intermittent connectivity issue between two subnets, VLAN 20 and VLAN 30. They suspect a routing loop or a duplicate IP address might be the cause. The administrator wants to trace the Layer 3 path from the default gateway of VLAN
20 (SW-1) to a host in VLAN 30.
Which troubleshooting steps are most effective for diagnosing this issue? (Choose 2.)

• A.Use `ping <vlan30_host_ip> repeat 100` on SW-1 to confirm the intermittent nature of the problem.
• B.Use `show mac-address-table` on SW-1 to find the IP address of the host.
• C.Use `show spanning-tree` on SW-1 to check the Layer 3 routing topology.
• D.Use `traceroute <vlan30_host_ip>` on SW-1 to identify the routing path and any potential loops.
• E.Use `show arp | include <vlan30_host_ip>` on SW-1 to check for a valid ARP entry.

Comment: *

Name: *

Email: *

Verification: *

A Solutions Architect is designing a highly available core layer for a campus network using two HPE Aruba Networking CX 8325 switches. The primary goals are to provide a single, unified management point, eliminate Spanning Tree Protocol (STP) for core links, and ensure seamless failover for downstream access layer switches and connected devices. The architect has chosen to implement Virtual Switching Framework (VSF) to stack the two core switches. What is the primary benefit of using VSF in this design compared to traditional redundancy protocols like STP?

• A.It provides faster convergence than STP by using Layer 3 OSPF for loop prevention.
• B.It increases the number of available physical ports by combining the ports of both switches.
• C.It allows both switches in the stack to actively forward traffic simultaneously, effectively doubling the core bandwidth.
• D.It simplifies IP address management by assigning a separate IP address to each switch in the stack.

Comment: *

Name: *

Email: *

Verification: *