A Network Technician is configuring a new AOS-CX switch to enable it to route traffic between different VLANs. The switch has several VLANs with IP addresses (SVIs) already configured.
Which single command must be enabled in the global configuration context to activate the switch's Layer 3 routing capabilities?

• A.`enable`
• B.`ip routing`
• C.`ip default-gateway`
• D.`router ospf 1`

Comment: *

Name: *

Email: *

Verification: *

While investigating a fault, you discovered that a LAG interface from an aggregation switch was connected to two different access switches.
How can you re-configure the LAG interface so it will only come up if connected to the same access switch?

• A.Enable LLDP on both switches.
• B.Change the hash algorithm.
• C.Configure a static lag.
• D.Configure a dynamic lag.

Comment: *

Name: *

Email: *

Verification: *

Which is at the Transport Layer of the OSI model?

• A.IP Address
• B.TCP Port
• C.MAC Address
• D.Switch Port

Comment: *

Name: *

Email: *

Verification: *

You have added the configuration below, but your auditor cannot execute 'view the software version' on the switch. What is the issue with the configuration you have applied?

• A.'show version' is not a supported command for CX switches.
• B.The first command in the permit CLI list was overwritten.
• C.The command "enable" needs to be included as the first entry.
• D.The word audit is system-reserved and cannot be used.

Comment: *

Name: *

Email: *

Verification: *

Which are true for providing dynamic IP addresses (DHCP) for hosts in a VLAN? (Select two)

• A.Using static routes, an AOS-CX switch can forward DHCP discovery packets to the DHCP server.
• B.AOS-CX switches do not support hosts with dynamic IP addresses.
• C.A DHCP server could be attached (connected) to the same VLAN.
• D.Using the IP helper feature in a multilayer switch.

Comment: *

Name: *

Email: *

Verification: *