Designing the System Under Test (SUT) for testability is important for a good test automation approach and can also benefit manual test execution.
Which of the following is NOT a consideration when designing for testability?

• A.Re-useability: The code written for the SUT must be re-useable for other similar system.
• B.Clearly defined architecture: The SUT Architecture needs to provide clear and understandable interfaces giving control and visibility on all test levels.
• C.Control: the SUT needs to provide interfaces that can be used to perform actions on SUT.
• D.Observability: The SUT needs to provide interface that give insight into the system.

Comment: *

Name: *

Email: *

Verification: *

A defect in a SUT has been resolved and validated by an automated defect re-test in the current release of the software. This retest has now been addedto the automated regression test suite.
Which statement BEST describes a reason why this defect could re-occur in future releases?

• A.The automated regression test suite has a narrower scope of functionality
• B.The configuration management process does not properly control the synchronization between software archives
• C.The automated regression test suite is not run consistently for future releases.
• D.Automated defect confirmation testing is not effective at confirming that the resolved defect will continue to work in future releases

Comment: *

Name: *

Email: *

Verification: *

Which of the following metrics could suggest, under certain condition that an automated regression test suite has NOT been updated for new functionalities added to the SUT?

• A.The ratio of comments to executable statements in the SUT code.
• B.The SUT code coverage provided by the execution of the regression test suite.
• C.The ratio of commands to executable statements in the automation code of the regression test suite
• D.The defect density in the automation code of the regression test suite.

Comment: *

Name: *

Email: *

Verification: *

Your goal is to verify completeness, consistency and correct behavior of an automated test suite. The TAS has been proven to successfully install in the SUT environment. All the preliminary checks to verify the correct functioning of the automated test environment and test tool configuration, installation and setup have successfully completed.
Which of the following is NOT a relevant check for achieving your goal in this scenario?

• A.Checking whether all the test cases produce repeatable outcomes
• B.Checking whether theloading of the TAS is repeatable in the SUT environment
• C.Checking whether the post condition have been fulfilled for all the test cases
• D.Checking whether all the test cases contain the expected results

Comment: *

Name: *

Email: *

Verification: *

You identified a suitable project to pilot an automation tool and planned and conduced a pilot. The pilot has been successful and tool Is being deployed within your organization, with a plan to increase tool use by the one project at a time. During this rollout some test processes will be changed slightly to gain additional benefits from using the tool.
In the pilot project, a small set of manual tests were automated for the first time. You are currently monitoring the test automation efficiency and this reveals that the automationregimefor the tests is not yet mature.
Which of the following statements is TRUE?

• A.The approach used for deployed this tool is aligned to the standard success factor for deployment
• B.The pilot project should have been critical so that maximum benefits were delivered
• C.The test process should be radically changed to gain additional benefits from using the tool.
• D.The target defined for the project was inappropriate, because the automationregimeforthe automated tests at the end of the pilot is not yet mature.

Comment: *

Name: *

Email: *

Verification: *