As a result of the RAD based development approach, the test manager has decided to change the risk mitigation approach. Which test technique might be most appropriate to use? 2 credits

• A.Decision Table Testing
• B.Exploratory Testing
• C.Boundary Value Analysis
• D.Error Guessing

Comment: *

Name: *

Email: *

Verification: *

Since the system is in the medical domain and therefore in the safety critical area, testing needs to be rigorous and evidence is required that the system has been adequately tested. Identify THREE measures that would typically be part of the test approach in this domain and which are not always applicable in other domains! 1 credit

• A.High level of documentation
• B.Master test planning
• C.Non-functional testing
• D.Failure Mode and Effect Analysis (FMEA) sessions
• E.Traceability to requirements
• F.Test design techniques
• G.Reviews

Comment: *

Name: *

Email: *

Verification: *

You are monitoring the test results for the first week of system test execution to ensure they conform to the test plan objectives. You are guided by the list of test conditions and traceability matrix produced following test design. Test Plan objectives
* Approach - Risk-based and depth first
* Status reporting - Execution statuses must be either "Passed*, "Failed", "Blocked" or "Not Run"
* Traceability - Test execution results must be traceable back to the test conditions Test Conditions

Traceability matrix
Which one of the following is a correct statement regarding the current status of test plan objectives?
SELECT ONE OPTION

• A.Only Approach and Traceability objectives have been met.
• B.All the Traceability objective has been met.
• C.None of the objectives have been met.
• D.All objectives have been met.

Comment: *

Name: *

Email: *

Verification: *

You are testing a new product that will turn on the windshield wipers of a car when the sensors detect there is moisture on the windshield. Depending on the information returned from the sensors, the wipers will be turned on at one of the following speeds: slow intermittent, medium intermittent, fast intermittent, slow constant, medium constant, fast constant. Your team has identified the following test condition:
Test Condition 1.1.1 - Verify that the windshield wipers can go from slow constant to fast constant speed when the amount of moisture increases appropriately.
Your team has defined the following steps for a test case for this test condition:
1. Set the moisture sensor to request slow constant
2. Increase the moisture to set the sensor to request fast constant
3. Verify that the wipers respond with fast constant speed
Given this information, which of the following statements is correct? [2]

• A.This test case is traceable to the test condition and provides 100% requirements coverage of the defined test condition.
• B.There is not enough information in the test condition to define a test case.
• C.This test case is not traceable to the test condition.
• D.The test case is traceable to the test condition and provides 100% statement coverage of the defined test condition.

Comment: *

Name: *

Email: *

Verification: *

When summarising test planning, which of the following statements is TRUE?

• A.Test planning involves estimating the required test resources such as test staff, tools and environment resources then allocating them to the test activities.
• B.It is not necessary for all stakeholders to accept the test plan, as disagreements are inevitable. However, it must be accepted by the project manager.
• C.Test planning is best started after the requirements have been identified, so the testing scope can be clearly understood and documented.
• D.Test planning activities start once all product risks have been identified and analyzed. Test planning then selects the risk treatment approaches.

Comment: *

Name: *

Email: *

Verification: *