Exhibit:

R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)

• A.Configure muitipath under group R1.
• B.Apply the prepend policy as an import policy under group R3.
• C.Apply the prepend policy as an import policy under group R1.
• D.Configure muitipath under the global BGP configuration.

Comment: *

Name: *

Email: *

Verification: *

You want to allow the load balancing of traffic for an EBGP route from two different peers in the same AS.
Which three actions are needed to accomplish this task? (Choose three.)

• A.At least two interfaces should be connected to the same EBGP neighbor
• B.An equal cost AS path for the route is required.
• C.A policy to load-balance traffic should be applied to the forwarding table
• D.The multipath parameter should be configured under protocols BGP
• E.The multihop parameter should be configured under protocols BGP

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

CE-1, CE-2, and CE-3 are part of a single VPLS VPN An Ethernet frame has just arrived at PE-3 from CE-3.
It has a source MAC address of CE-3 and a destination MAC address of CE-1. You want to know what PE-3 does with the Ethernet frame.
Referring to the exhibit, which statement is correct?

• A.It forwards the packet to PE-1 and PE-2.
• B.It forwards the packet to PE-1 only.
• C.It drops the packet because the destination MAC address is not in PE-3's MAC table.
• D.It drops the packet because the destination MAC address is not for PE-3.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Which three statements are true about the show pim join output shown in the exhibit? (Choose three.)

• A.The shortest path to the source is through the RP
• B.This is a source-specific multicast stream. G The multicast receiver is still using the RP to receive the stream.
• C.The multicast stream has been configured with a backup path to allow for fast reroute.
• D.The multicast stream does not have an RP.

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, which OSPFv3 configuration is implemented on router R1?
set protocols ospf3 area 0.0.0.0 interface ge-0/0/0.0

• A.set protocols ospf3 area 0.0.0.1 interface ge-0/0/1.0
  set protocols ospf3 area 0.0.0.1 interface ge-0/0/0.0 secondary
  set protocols ospf3 area 0.0.0.0 interface ge-0/0/0.0
• B.set protocols ospf3 area 0.0.0.1 interface ge-0/0/1.0
  set protocols ospf3 area 0.0.0.1 virtual-link neighbor-id 172.16.1.2
  set protocols ospf3 area 0.0.0.0 interface ge-0/0/0.0
• C.set protocols ospf3 area 0.0.0.1 interface ge-0/0/1.0
  set protocols ospf3 area 0.0.0.1 interface ge-0/0/0.0
  set protocols ospf3 area 0.0.0.0 interface ge-0/0/0.0
• D.set protocols ospf3 area 0.0.0.1 interface ge-0/0/1.0
  set protocols ospf3 area 0.0.0.1 interface ge-0/0/0.0 interface-type p2p

Comment: *

Name: *

Email: *

Verification: *