Which two statements about VXLAN are true? (Choose two.)

• A.A VTEP is virtual or physical device that maps end devices to VXLAN segments.
• B.Devices that terminate VXLAN tunnels are known as VTEPs.
• C.VXLAN uses a UDP destination port 4987.
• D.VXLAN adds an additional 32 bytes worth of headers.

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, Host 1 and Host 3 have exchanged traffic.

`
In this scenario, which statement is true?

• A.Leaf 2 learns Host 1's MAC address through periodic updates from Spine 2.
• B.Leaf 2 learns Host 1's MAC address when Host 3 learns Host 1's MAC address.
• C.Leaf 2 does not learn Host 1's MAC address until Host 1 and Host 2 send traffic to each other.
• D.Leaf 2 learns Host 1's MAC address when Leaf 1 queries Host 1.

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?

• A.VXLAN Layer 3 gateway must be provisioned at the Super Spine layer.
• B.A route to the loopback address on VTEP must be present on VTEP1.
• C.VTEP and VTEP2 must peer using IBGP.
• D.The service provider WAN connection be an MPL5-based WAN connection.

Comment: *

Name: *

Email: *

Verification: *

You have configured MP-IBGP to support EVPN for your overlay network. However, you are not seeing the expected routes on your edge devices.

Referring to the exhibit, how would you solve this problem?

• A.The group types on both devices should be set to external
• B.Graceful restart must be disabled for this session
• C.The family 12vpn signaling must be configured on the local peer
• D.The family evpn signaling parameter must be configured on the remote peer.

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, SW-3 and SW-4 have been configured for mixed-mode VCF and added to the VCF. After cabling the new devices into the VCF, you notice that SW-3 automatically joins the VCF, whereas SW-4 does not.
Why are SW-3 and SW-4 behaving this way? (Choose two.)

• A.By default, QFX5100 ports are not enabled as VCPs.
• B.By default, EX4300 QSFP+ ports are enabled as VCPs.
• C.By default, QFX5100 ports are enabled as VCPs.
• D.By default, EX4300 QSPF+ ports are not enabled as VCPs.

Comment: *

Name: *

Email: *

Verification: *