You are asked to create an interface group on a NetApp clustered Data ONTAP system. The system is connected to a Cisco Nexus switch in a vPC configuration with the port-channel mode set to active.
Which NetApp interface group made matches this switch configuration?

• A.mode active
• B.multimode
• C.singlemode
• D.multimode_lacp

Comment: *

Name: *

Email: *

Verification: *

Which two operating modes are available with the Nexus 9000 Series switches? (Choose two.)

• A.Cisco IOS EX
• B.Cisco IOS
• C.Cisco ACI
• D.Cisco NX-OS

Comment: *

Name: *

Email: *

Verification: *

When using Clustered Data ONTAP 8.1 and later, what is the default for new aggregates?

• A.Vserver aggregates
• B.traditional aggregates
• C.cluster aggregates
• D.128-bit aggregates
• E.32-bit aggregates
• F.64-bit aggregates

Comment: *

Name: *

Email: *

Verification: *

When connecting the Nexus 1110-X to the Nexus switch, what Spanning Tree port type is used?

• A.Edge trunk
• B.Edge
• C.Network
• D.Trunk
• E.Normal

Comment: *

Name: *

Email: *

Verification: *

Given the following switch output, where would you expect see notification level messages?
N5K-1# show logging info.
Logging console: enabled (Severity: error)
Logging monitor: enabled (Severity: informational)
Logging linecard: enabled (Severity: emergency)
Logging fex: enabled (Severity: notifications)
Logging time stamp: seconds
Logging server: disabled
Logging logfile: enabled

• A.On the linecard
• B.On the terminal sessions
• C.On the console
• D.Notification messages will not be seen anywhere

Comment: *

Name: *

Email: *

Verification: *