You are asked to install the Virtual Supervisor Module (VSM) software on a Nexus 1000v switch.
Which two sources would you use to install this software? (Choose two.)

• A.PXE boot
• B.ISO image
• C.VSC plug-in
• D.OVA file

Comment: *

Name: *

Email: *

Verification: *

Which three are characteristics of a NAS data LIF? (Choose three.)

• A.It can be associated with an Ethernet port or VLAN interface.
• B.It can be associated with a Fibre Channel port.
• C.It can be associated with a WWPN
• D.It can be associated with an IP address.
• E.It is associated with the administrative Vserver.
• F.It can be associated with an interface group (ifgrp).
• G.It is associated with the management LIF.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

An administrator is configuring a NetApp 8-node AFF8060 system as part of a FlexPod solution and will be cabling the system based on the recommended guidelines shown in the exhibit.
Based on this information, which switch would be used for the cluster interconnect connections?

• A.Nexus 5596
• B.NetApp CN1601
• C.Nexus 5548
• D.NetApp CN1610

Comment: *

Name: *

Email: *

Verification: *

NetApp recommends that your SSL key length be?

• A.512
• B.768
• C.1024
• D.9216

Comment: *

Name: *

Email: *

Verification: *

The storage administrator created an export policy for a volume on a NetApp cluster.
The export policy contains a single export rule with the parameters shown below.
- protocol nfs - rorule any
- clientmatch 10.1.16.0/255.255.255.0 - rwrule any
Two hosts attempt to access the volume using the NFS protocol shown below.
- HostA with IP address 10.1.17.37 sends an access request using the NFSv3 protocol
- HostB with IP address 10.1.16.24 sends an access request using the NFSv4 protocol
Which statement about this scenario is true?

• A.HostA's access to the volume will be blocked by the protocol parameter; HostB will be granted RO/RW access to the volume.
• B.HostA will be granted RO/RW access to the volume; HostB's access to the volume will be blocked by the protocol parameter.
• C.HostA's access to the volume will be blocked by the clientmatch parameter; HostB will be granted RO/RW access to the volume.
• D.HostA's access to the volume will be blocked by the clientmatch parameter; HostB's access to the volume will be blocked by the protocol parameter.

Comment: *

Name: *

Email: *

Verification: *