A FAS system that is backed by 7200 RPM drives is experiencing extremely latent writes and slow but less latent reads.

Referring to the exhibit, what are two reasons for this result? (Choose two.)

• A.The disks are latent.
• B.The controller is in back-to-back consistency points.
• C.Indirect I/O is causing most of the latency.
• D.NVRAM is too small for the controller.

Comment: *

Name: *

Email: *

Verification: *

You have a 4-node cluster configured for FC. You create a new LUN on node 1, map the LUN to a host, and verify that the host is able to correctly access the LUN. However, after moving the LUN's volume to node 3, ALUA reports that all the paths are non-optlmized. You have already verified that all zoning and physical cabling is correct.
What should you do to enable ALUA to see the optimized paths?

• A.Update the igroup initiator WWPN.
• B.Update the reporting nodes for the LUN mapping.
• C.Update the MPIO policy to round-robin.
• D.Update the MPIO policy to most recently used.

Comment: *

Name: *

Email: *

Verification: *

In which three scenarios is it possible to disable and remove the aggregate Snapshot copy? (Choose three.)

• A.You are protecting the aggregate with RAID-DP.
• B.You are protecting volumes using SnapMirror DP.
• C.You are protecting volumes using SnapMirror XDP.
• D.Your cluster is part of a MetroCluster configuration.
• E.You are protecting the aggregate using SyncMirror.

Comment: *

Name: *

Email: *

Verification: *

How many drive bays does a DS4246 shelf have?

• A.46
• B.12
• C.24
• D.42

Comment: *

Name: *

Email: *

Verification: *

A customer is trying to enable NVMe and wants to use the FC adapters in the controllers but cannot enable the protocol.

Referring to the exhibit, what is causing the problem?

• A.There are no FC adapters installed with a max-speed of 32Gbps.
• B.There are no FC adapters installed with a physical protocol set to NVMe.
• C.There are no FC adapters installed with a media type of NVMe.
• D.There are no FC adapters installed with the speed set to 32Gbps.

Comment: *

Name: *

Email: *

Verification: *