Your customer's initial measurement data (IMD) has been imported and can be viewed through the Measuring Component portal, but is not in the "Final" measurement status.
What can you assume that the IMD has passed?

• A.Critical Validation
• B.Critical Validation, High/Low Check Validation, and Sum Check Validation
• C.Multiplier Check Validation
• D.Sum Check Validation
• E.High/Low Check Validation

Comment: *

Name: *

Email: *

Verification: *

How do you ensure that specific Validation, Editing, and Estimation (VEE) rules are applied to estimated measurements?

• A.by adding the VEE Group as the Fallback VEE Group for the appropriate VEE role
• B.by adding the estimation rules to the Manual Override VEE Group to the Measuring Component Type
• C.by adding the VEE Group to the Device Type
• D.by adding the VEE Group to the Device Configuration Type

Comment: *

Name: *

Email: *

Verification: *

How many derived values can a final measurement have in addition to the primary measured value?

• A.5
• B.15
• C.10
• D.2

Comment: *

Name: *

Email: *

Verification: *

Which three statements are true about initial measurements, final measurements, and usage? (Choose three.)

• A.A service point can have more than one initial measurement for the same period, but only one final measurement.
• B.Usage is loaded in the application to generate final measurements.
• C.Usage is a synonym for bill determinants.
• D.The initial measurement data can be optionally stored in Raw format.
• E.Final measurements can be directly edited or updated by users or by automated processes as required.

Comment: *

Name: *

Email: *

Verification: *

Your client has the following requirements:
Many customers are installing their own solar electrical generation equipment. When these customers generate more electricity than required for their own use, the surplus can he exported back to the power grid.
In order to measure this generation, we have installed special scalar devices. These devices have separate registers to measure the energy generated (export) and the energy received (import) from the National Grid. Both reads will be stored in kWh, but the import is subtractive and export is consumptive.
What solution should you choose to configure the measuring component types for these specific requirements?

• A.Create one new measuring component type for creating two measuring components (one for import and the other for export) that will be linked to one scalar device.
• B.Create two service points: one for subtractive import and the other for consumptive export.
• C.Create two new measuring component types (one for subtractive import and the other for consumptive export) to enable the creation of two measuring components that will be linked to one scalar device.
• D.Create one new measuring component type for creating a new measuring component that will be linked to two different scalar devices (one for import and the other for export).

Comment: *

Name: *

Email: *

Verification: *