Which troubleshooting step should be taken when users at a branch site are experiencing a maximum throughput of 200 Mbps for Direct Internet Access (DIA) traffic on a 1 Gbps internet connection?

• A.Ensure QoS policy is applies to the site.
• B.Ensure the WAN interface is set to 1 Gbps or auto mode.
• C.Ensure performance policy is applied to the site.
• D.Ensure the circuit configuration at the site level is properly set.

Comment: *

Name: *

Email: *

Verification: *

An administrator has configured a Zone-Based Firewall (ZBFW) policy on a branch ION. They created a rule to "Allow" traffic from the "Guest" zone to the "Internet" zone. However, users in the "Guest" zone are reporting they cannot reach a specific public website, and the Flow Browser shows the flow state as
"REJECT".
What is the most likely reason for this specific rejection, assuming the "Allow" rule is correctly placed at the top of the list?

• A.The implicit default action at the bottom of the security policy is "Deny All".
• B.The "Allow" rule does not have the specific "Application" defined (it is set to Any), causing a mismatch.
• C.There is a "Deny" rule in the "Global" policy stack that is taking precedence over the "Local" site rule.
• D.The ION device does not support firewalling for HTTP traffic.

Comment: *

Name: *

Email: *

Verification: *

A network installer is at a remote branch site to deploy a new ION 3000 device. The device has been racked, cabled to the internet, and powered on. The installer has the "Claim Code" displayed on the email sent by the administrator.
When the administrator enters this Claim Code into the Prisma SD-WAN portal, what is the immediate status of the device before the configuration is fully pushed?

• A.Online
• B.Claimed
• C.Provisioned
• D.Active

Comment: *

Name: *

Email: *

Verification: *

During the Zero Touch Provisioning (ZTP) process of a new ION device at a branch site, which interface ports are supported by default to request an IP address via DHCP and reach the Prisma SD-WAN controller for claiming?

• A.Only the dedicated Controller port (if available)
• B.Any LAN or WAN port on the device
• C.The dedicated Controller port, or Port 1 / Internet 1 if a dedicated port is absent
• D.Only the USB port via a cellular modem

Comment: *

Name: *

Email: *

Verification: *

An administrator has configured a Path Policy for "ERP_Traffic". The policy allows two public internet links, "ISP-A" and "ISP-B", both marked as "Active". The Path Quality Profile (SLA) requires a latency of less than 150ms. Currently, both ISP-A and ISP-B have a latency of 40ms, well within the SLA.
How does the Prisma SD-WAN ION determine which link to use for a new flow of "ERP_Traffic" when both active paths meet the SLA requirements?

• A.It selects the path with the lowest numerical latency (e.g., if ISP-A drops to 39ms).
• B.It selects the path with the highest available bandwidth capacity.
• C.It duplicates the packets across both paths (Packet Duplication) to ensure delivery.
• D.It selects the path that appears first in the interface configuration list.

Comment: *

Name: *

Email: *

Verification: *