DRAG DROP
Drag and drop the DCNM configuration tasks from the left onto the correct tools on the right.
Select and Place:

Correct Answer:

Section: Management and Monitoring

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. The san-user must configure FSPF on the VSAN 500. but fails. An operator with network administrative rights must authorize the san-user to perform this work. Which configuration must the operator apply?

• A.MDS-A(config)# role name sangroup
  MDS-A(config-role># no rule 2
• B.MDS-A(config)# role name sangroup
  MDS-A(config-role)# rule 4 permit config feature fspf
• C.MDS-A(config)# role name sangroup
  MDS-A(config-role)# vsan policy deny
  MDS-A(config-role-vsan)# permit vsan 500
• D.MDS-A(config)# role name sangroup
  MDS-A(config-role)# rule 2 permit config feature vsan

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibits.


A storage network engineer activates a zoneset on MDS-A and verifies the successful activation (Exhibit 1).
The engineer is then notified that there is a SAN outage (Exhibit 2) What is the cause of the outage?

• A.Another network engineer activated zoneset ZoneSetMDS-B-VSAN100 on MDS-A.
• B.Another network engineer issued the zone mode enhanced vsan 100 command on another switch in the fabric.
• C.Another network engineer activated the zoneset ZoneSetMDS-B-VSAN100 command on another switch in the fabric.
• D.Another network engineer issued the zone default-zone permit vsan 100 command on another switch in the fabric.

Comment: *

Name: *

Email: *

Verification: *

Drag and Drop Question
Drag and drop the boot issues from the left onto the correct solutions on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network engineer created a new user that uses the VSAN-Admin role on a Cisco MDS switch so a new colleague can manage the VSANs configured on the switch. Which action is required for the configuration to give permission to the new colleague?

• A.permit vsan 1-1000 must be configured as rule 5.
• B.permit vsan 1-1000 must be configured as rule 1.
• C.permit vsan 1-1000 must be configured under the VSAN policy deny.
• D.permit vsan 1-1000 must be configured under the VSAN policy allow.

Comment: *

Name: *

Email: *

Verification: *