Refer to the exhibits. A storage network engineer activates a zoneset on MDS-A and verifies the successful activation (Exhibit 1). The engineer is then notified that there is a SAN outage (Exhibit
2). What is the cause of the outage?

• A.Another network engineer issued the zone default-zone permit vsan 100 command on another switch in the fabric.
• B.Another network engineer issued the zone mode enhanced vsan 100 command on another switch in the fabric.
• C.Another network engineer activated zoneset ZoneSetMDS-B-VSAN100 on MDS-A.
• D.Another network engineer activated the zoneset ZoneSetMDS-B-VSAN100 command on another switch in the fabric.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A storage network engineer gets remote access to two Cisco MDS 9000 Series Switches with an ISL trunk and receives several log messages. Which set of actions resolve the problem while least affecting service?

• A.1. Deactivate zone set Zoneset10-A on MDS-A.
  2. shut/no shut interface fc1/11 on MDS-A.
• B.1. Add :11:11:11:11:11:11:11:13 pwwn in zone Server11 and activate Zoneset10-A on MDS-A.
  2. shut/no shut interface fc1/11 on MDS-A.
• C.1. Explicitly import zone set Zoneset10-A on MDS-B using the zoneset import interface import fc1/11 vsan 10 command.
  2. Activate the zone set Zoneset10-A.
• D.1. Add :11:11:11:11:11:11:11:13 pwwn in zone Server11 and activate Zoneset10-A on MDS-A.
  2. Remove VSAN 10 from the allowed VSAN range of interface fc1/11 on MDS-A and add it back in the range.

Comment: *

Name: *

Email: *

Verification: *

Which condition requires using a device alias rather than a Fibre Channel alias?

• A.The zone database must be distributed over the fabric.
• B.The same alias must be used in zoning as well as DPVM.
• C.All aliases being used are being configured in the same VSAN.
• D.Aliases must be saved within a central database on the fabric.

Comment: *

Name: *

Email: *

Verification: *

Which statement about FCoE is true?

• A.Not a single FCoE VLAN can map to multiple VSANs.
• B.Inter-switch FCoE links can be configured to carry multiple VSANs.
• C.FCoE is not supported on any Nexus 2000 Series Fabric Extenders.
• D.FCoE does not support NPV/NPIV mode.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. Which command is used to determine which switch has the lock?

• A.show zoneset active
• B.show zont status
• C.show fcs ie vsan
• D.show flogi database

Comment: *

Name: *

Email: *

Verification: *