The principal switch on a Fibre Channel network fails to assign requested domain to a subordinate switch. What are two reasons? (Choose two.)

• A.Cisco Fabric Services distribution is not enabled on the switch.
• B.The persistent FC ID feature is not enabled.
• C.The requested domain is outside the allowed list.
• D.An existing switch already has the requested domain assigned.
• E.The fabric is locked.

Comment: *

Name: *

Email: *

Verification: *

Which configuration is always required when running the setup utility on a Cisco MDS 9000 Series Switch?

• A.administrator password
• B.management IP address
• C.active NTP server
• D.active default gateway

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The san-user must configure FSPF on the VSAN 500, but fails. An operator with network administrative rights must authorize the san-user to perform this work. Which configuration must the operator apply?

• A.MDS-A(config)# role name sangroup
  MDS-A(config-role)# no rule 2
• B.MDS-A(config)# role name sangroup
  MDS-A(config-role)# rule 4 permit config feature fspf
• C.MDS-A(config)# role name sangroup
  MDS-A(config-role)# vsan policy deny
  MDS-A(config-role-vsan)# permit vsan 500
• D.MDS-A(config)# role name sangroup
  MDS-A(config-role)# rule 2 permit config feature vsan

Comment: *

Name: *

Email: *

Verification: *

Two stable fabrics have overlapping domains. After a switch from the first domain is joined to a switch from the second domain, both switches become isolated. What caused the problem?

• A.The autoreconfigure option is disabled on both switches.
• B.The autoreconfigure option is enabled on both switches.
• C.The rcf-reject option is enabled on the interfaces.
• D.The rcf-reject option is disabled on the interfaces.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibits A storage network engineer activates a zoneset on MDS-A and verifies the successful activation (Exhibit 1) The engineer is then notified that there is a SAN outage (Exhibit 2) What is the cause of the outage?

• A.Another network engineer activated zoneset ZoneSetMDS-B-VSAN100 on MDS-A.
• B.Another network engineer issued the zone default-zone permit vsan 100 command on another switch in the fabric.
• C.Another network engineer activated the zoneset ZoneSetMDS-B-VSAN100 command on another switch in the fabric.
• D.Another network engineer issued the zone mode enhanced vsan 100 command on another switch in the fabric.

Comment: *

Name: *

Email: *

Verification: *