Refer to the exhibit.

You have just created a new VRF on PE3. You have enabled debug
ip bgp vpnv4 unicast updates on PE1, and you can see the route in the debug, but not in the BGP VPNv4 table. Which two statements are true? (Choose two)

• A.After you configure route-target import 999:999 for a VRF on PE1, the route will be accepted
• B.VPNv4 is not configured between PE1 and PE3
• C.address-family ipv4 vrf is not configured on PE3
• D.PE1 will reject the route due to automatic route filtering
• E.After you configure route-target import 999:999 for a VRF on PE3, the route will be accepted Because some PE routers might receive routing information they do not require, a basic

Comment: *

Name: *

Email: *

Verification: *

Which statement about VXLAN is true?

• A.VXLAN uses the Spanning Tree Protocol for loop prevention.
• B.VXLAN encapsulates a Layer 2 frame in an IP-UDP header, which allows Layer 2 adjacency across router boundaries.
• C.VXLAN extends the Layer 2 Segment ID field to 24-bits, which allows up to 4094 unique Layer 2 segments over the same network.
• D.VXLAN uses TCP as the transport protocol over the physical data center network.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The WLC administrator sees that the controller to which a roaming client associates has Mobility Role Anchor configured under Clients > Detail. Which type of roaming is supported?

• A.Layer 2 intercontroller
• B.Intracontroller
• C.Layer 3 intercontroller
• D.Indirect

Comment: *

Name: *

Email: *

Verification: *

AN engineer is implementing MPLS OAM to monitor traffic within the MPLS domain. Which action must the engineer perform to prevent from being forwarded beyond the service provider domain when the LSP is down?

• A.Disable IP redirects on all ingress interfaces
• B.Implement the destination address for the LSP echo request packet in the 127.x.y.z/8 network
• C.Disable IP redirects only on outbound interfaces
• D.Configure a private IP address as the destination address of the headend router of Cisco MPLS TE.

Comment: *

Name: *

Email: *

Verification: *

Which statements are used for error handling in Python?

• A.try/catch
• B.catch/release
• C.block/rescue
• D.try/except

Comment: *

Name: *

Email: *

Verification: *