What is the function of a VTEP in VXLAN?

• A.statically point to end host locations of the VXLAN fabric
• B.dynamically discover the location of end hosts in a VXLAN fabric
• C.encapsulate and de-encapsulate traffic into and out of the VXLAN fabric
• D.provide the routing underlay and overlay for VXLAN headers

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are mode, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem?

• A.The port channel on SW2 is using an incompatible protocol.
• B.The port-channel trunk is not allowing the native VLAN.
• C.The port-channel should be set to auto.
• D.The port-channel interface lead balance should be set to src-mac

Comment: *

Name: *

Email: *

Verification: *

What is the purpose of an RP in PIM?

• A.send join messages toward a multicast source SPT
• B.ensure the shortest path from the multicast source to the receiver.
• C.receive IGMP joins from multicast receivers.
• D.secure the communication channel between the multicast sender and receiver.

Comment: *

Name: *

Email: *

Verification: *

Which method displays text directly into the active console with a synchronous EEM applet policy?

• A.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 gets 'logging directly to console'
• B.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 syslog priority direct msg 'log directly to console'
• C.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 puts 'logging directly to console'
• D.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 string 'logging directly to console'

Correct Answer: B

Explanation
To enable the action of printing data directly to the local tty when an Embedded Event Manager (EEM) applet is triggered, use the action puts command in applet configuration mode.
The following example shows how to print data directly to the local tty:

The action puts command applies to synchronous events. The output of this command for a synchronous applet is directly displayed to the tty, bypassing the syslog.
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/eem/command/eem-cr-book/eemcr- a1.html

Comment: *

Name: *

Email: *

Verification: *

Which congestion queuing method on Cisco IOS based routers uses four static queues?

• A.custom
• B.low latency
• C.Priority
• D.weighted fair

Comment: *

Name: *

Email: *

Verification: *