Refer to the exhibit. A network engineer configures show command to verify the configuration What does the output confirm?

• A.A Telnet from 160.1.1 1 to 10.1.1.10 has been initiated.
• B.R1 to configured with PAT overload parameters
• C.R1 is configured with NAT overload parameters
• D.The first pocket triggered NAT to add on entry to NAT table

Comment: *

Name: *

Email: *

Verification: *

What it the purpose of the LISP routing and addressing architecture?

• A.It allows multiple instances of a routing table to co-exist within the same router.
• B.It creates head-end replication used to deliver broadcast and multicast frames to the entire network.
• C.It creates two entries for each network node, one for its identity and another for its location on the network.
• D.It allows LISP to be applied as a network virtualization overlay though encapsulation.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer must create a configuration that executes the show run command and then terminates the session when user CCNP legs in. Which configuration change is required''

• A.Add the autocommand keyword to the username command
• B.Add the access-class keyword to the username command
• C.Add the autocommand keyword to the aaa authentication command
• D.Add the access-class keyword to the aaa authentication command

Comment: *

Name: *

Email: *

Verification: *

What is a Type 1 hypervisor?

• A.runs directly on a physical server and depends on a previously installed operating system
• B.runs directly on a physical server and includes its own operating system
• C.runs on a virtual server and depends on an already installed operating system
• D.run on a virtual server and includes its own operating system

Comment: *

Name: *

Email: *

Verification: *

What is the function of a control-plane node in a Cisco SD-Access solution?

• A.to connect external Layer 3 networks to the SD Access fabric.
• B.to implement policies and communicate with networks outside the fabric
• C.to connect APs and wireless endpoints to the SD-Access fabric
• D.to run a mapping system that manages endpoint to network device relationships

Comment: *

Name: *

Email: *

Verification: *