Refer to the exhibit.

An engineer must configure HSRP for VLAN 1000 on SW2. The secondary switch must immediately take over the role of active router If the interlink with the primary switch fails. Which command set completes this task?
A)

B)

C)

D)

• A.Option B
• B.Option D
• C.Option A
• D.Option C

Comment: *

Name: *

Email: *

Verification: *

Which three methods does Cisco DNA Centre use to discover devices? (Choose three)

• A.CDP
• B.SNMP
• C.LLDP
• D.ping
• E.NETCONF
• F.a specified range of IP addresses

Correct Answer: A,C,F

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A GRE tunnel has been created between HO and BR routers.
What is the tunnel IP on the HQ router?

• A.10.111.111.1
• B.10.111.111.2
• C.209.165.202.130
• D.209.165.202.134

Correct Answer: A

In the above output, the IP address of "209.165.202.130" is the tunnel source IP while the IP 10.111.1.1 is the tunnel IP address.
An example of configuring GRE tunnel is shown below:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer configures a new HSRP group. While reviewing the HSRP status, the engineer sees the logging message generated on R2. Which is the cause of the message?

• A.The HSRP configuration has caused a spanning-tree loop
• B.A PC is on the network using the IP address 10.10.1.1
• C.The HSRP configuration has caused a routing loop
• D.The same virtual IP address has been configured for two HSRP groups

Comment: *

Name: *

Email: *

Verification: *

What is the purpose of the LISP routing and addressing architecture?

• A.It creates two entries for each network node, one for Its identity and another for its location on the network.
• B.It allows LISP to be applied as a network visualization overlay though encapsulation.
• C.It allows multiple Instances of a routing table to co-exist within the same router.
• D.It creates head-end replication used to deliver broadcast and multicast frames to the entire network.

Comment: *

Name: *

Email: *

Verification: *