Which tool is used in Cisco DNA Center to build generic configurations that are able to be applied on device with similar network settings?

• A.Command Runner
• B.Template Editor
• C.Application Policies
• D.Authentication Template

Comment: *

Name: *

Email: *

Verification: *

An administrator must enable Telnet access to Router X using the router username and password database for authentication. Which configuration should be applied?
A)

B)

C)

D)

• A.Option B
• B.Option A
• C.Option D
• D.Option C

Comment: *

Name: *

Email: *

Verification: *

A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1:

• A.Option D
• B.Option B
• C.Option A
• D.Option E
• E.Option C

Comment: *

Name: *

Email: *

Verification: *

Refer the exhibit.

Which router is the designated router on the segment 192.168.0.0/24?

• A.Router Chicago because it has a lower router ID
• B.This segment has no designated router because it is a p2p network type.
• C.This segment has no designated router because it is a nonbroadcast network type.
• D.Router NewYork because it has a higher router ID

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Link1 is a copper connection and Link2 is a fiber connection. The fiber port must be the primary port for all forwarding. The output of the show spanning-tree command on SW2 shows that the fiber port is blocked by spanning tree. An engineer enters the spanning- tree port-priority 32 command on GO/1 on SW2, but the port remains blocked. Which command should be entered on the ports that are connected to Link2 to resolve the issue?

• A.Enter spanning-tree port-priority 32 on SW1.
• B.Enter spanning-tree port-priority 4 on SW2.
• C.Enter spanning-tree port-priority 64 on SW2.
• D.Enter spanning-tree port-priority 224 on SW1.

Comment: *

Name: *

Email: *

Verification: *