A BIG-IP Administrator finds the following log entry:
tnm tmm[7141]: 011e0002:4: sweeperjjpdate: aggressive mode activated.
Which action should the BIG-IP Administrator to mitigate this memory issue?

• A.increase the TCP profile ide Timeout value
• B.Decrease the TCP profile ide Timeout value
• C.Configure the redundant par to be active-active
• D.Configure the serve to use Connection Mirroring

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator finds the following log entry after a report of user issues connecting to a virtual server:
01010201: 2: Inet port exhaustion on 10.70.110.112 to 192.28.123.250:80 (proto 6) How should the BIG-IP Administrator modify the SNAT pool that is associated with the virtual server?

• A.Remove the SNAT pool and apply SNAT Automap.
• B.Remove an IP address from the SNAT pool.
• C.Increase the timeout of the SNAT addresses.
• D.Add an address to the SNAT pool.

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP device is configured with both an internal external and two Corporate VLANs. The virtual server has SNAT enabled and is set to listen on all VLANs Auto Last Hop is disabled. The Corporate users are on
10.0.0.0./24 and 172.16.0.0/12. The BIG-IP has a Self-IP on the 1.0.0.0.0./24 subnet.
Internet users are able to access the virtual server. Only some of the Corporate users are able to connect to the virtual server A BIG-IP Administrator performs a tcpdump on the BIG-IP and verifies that traffic is arriving from users in 10.0.0.0/24.
What should the BIG-IP Administrator do to correct this behaviour?

• A.Add a static route for the 172.16.0.0/12 subnet
• B.Modify the default route of the servers to point to the BIG-IP device
• C.Change the default route to point to the extra firewall
• D.Disable the server on the internal VLAN

Comment: *

Name: *

Email: *

Verification: *

Assuming other failElover settings are at their default state, what would occur if the failElover cable were to be disconnected for five seconds and then reconnected.

• A.As long as network communication is not lost, no change will occur.
• B.When the cable is disconnected, both systems will become active. When the voltage is restored, both systems will maintain active mode.
• C.When the cable is disconnected, both systems will become active. When the voltage is restored, unit two will revert to standby mode.
• D.Nothing. FailElover due to loss of voltage will not occur if the voltage is lost for less than ten seconds.

Comment: *

Name: *

Email: *

Verification: *

Which statement is true concerning SSL termination.

• A.When any virtual server uses a ClientSSL profile, all SSL traffic sent to theElI BIP G is decrypted before it is forwarded to servers.
• B.A virtual server that has both ClientSSL and ServerSSL profiles can still support cookie persistence.
• C.If a virtual server has both a ClientSSL and ServerSSL profile, the pool members have less SSL processing than if the virtual server had only a ClientSSL profile
• D.Decrypting traffic at the BIGElIP allows the use of iRules for traffic management, but increases the load on the pool member.

Comment: *

Name: *

Email: *

Verification: *