A custom HTTP monitor is failing to a pool member 10.10.3.75:8080 that serves up www.example.com.
A ping works to the pool member address.
The SEND string that the monitor is using is: GET/HTTP/l.l/r/n/Host.www.example.com/r/n/Connection Close/r/n/r/n Which CLI tool syntax will show that the web server returns the correct HTTP response?

• A.curl-header 'Host:www.example.com' http://10.10.3.75:8080/
• B.curlhttp://10.10.10.3.75:8080/www.example.com/index.html
• C.tracepath 10.10.3.75:8080 GET /index
• D.tracepath 'http://www.example.com:80

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The BIG-IP Administrator has modified an iRule on one device of an HA pair. The BIG-IP Administrator notices there is NO traffic on the BIG-IP device in which they are logged into.
What should the BIG-IP Administrator do to verify if the iRule works correctly?

• A.Push configuration from this device to the group and start to monitor traffic on this device
• B.Pull configuration to this device to the cluster and start to monitor traffic on this device
• C.Log in to the other device in the cluster, push configuration from it, and start to monitor traffic on that device
• D.Log in to the other device in the cluster, pull configuration to it, and start to monitor traffic on that device

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An LTM device has a virtual server mapped to www.f5.com. Users report that when they connect to
/resources/201.1.2h.l_l.com they are unable to receive content.
What is the likely cause of the issue?

• A.The pool associated with the virtual server is falling its health check.
• B.The pool associated with the virtual server does not have priority group activation enabled.
• C.The virtual address does not have route advertising enabled.
• D.The virtual address does not have ARP enabled.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which TMSH command generated this output?

• A.tmsh list /sys sync-status
• B.tmsh show /sys sync-status
• C.tmsh list /cm sync-status
• D.tmsh show /cm sync status

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

According to the shown Configuration Utility stings What is the setting of the User Directory configuration under the Authentication submenu?

• A.Remote-TACACS+
• B.Managed
• C.Default system configuration
• D.Local

Comment: *

Name: *

Email: *

Verification: *