Which three methods can be used for initial access to a BIG-IP system? (Choose three.)

• A.SSH access to any of the switch ports
• B.HTTPS access to any of the switch ports
• C.HTTP access to the management port
• D.HTTPS access to the management port
• E.HTTP access to any of the switch ports
• F.CLI access to the serial console port
• G.SSH access to the management port

Comment: *

Name: *

Email: *

Verification: *

A site has six members in a pool. All of the servers have been designed, built, and configured with the same applications. It is known that each client's interactions vary significantly and can affect the performance of the servers.
If traffic should be sent to all members on a regular basis, which loadbalancing mode is most effective if the goal is to maintain a relatively even load across all servers?

• A.Round Robin
• B.Observed
• C.Priority
• D.Ratio

Comment: *

Name: *

Email: *

Verification: *

Refer of the exhibit.

The 816-IP Administrator runs the command shown and observes a device trust issue between BIG-IP devices in a device group. The issue prevents config sync on device bigip3.local.
What is preventing the config sync?

• A.Next Active Load factor is 0 on bigip1.local
• B.Both devices are standby
• C.Next Active Load factor is 1 on bigip1.local
• D.Time Delta to local system is 12

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?

• A.Increase the MTU on the VLAN using Interface 1.1
• B.Set the media speed of Interface 1.1 manually
• C.Assign two Interfaces to the VLAN
• D.Create a trunk object with two Interfaces

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator assigns the default http health monitor to a pool that has three members listening on port 80 When the administrator connects to each pool member via the CURL utility, two of the members respond with a status of 404 Not Found while the third responds with 200 OK. What will the pool show for member availability?

• A.All members online.
• B.All members offline.
• C.Two members offline and one member online.
• D.Two members online and one member offline.

Comment: *

Name: *

Email: *

Verification: *