The end users of a web application need to verify that their browsers received the complete message-body from the web server.
Which HTTP header will accomplish this?

• A.Range
• B.Expect
• C.Accept-Ranges
• D.Content-Length

Comment: *

Name: *

Email: *

Verification: *

-- Exhibit-

-- Exhibit -
Refer to the exhibits.
An LTM Specialist uses the information in the logs to determine the cause of a failover event in a high-availability (HA) pair.
What caused the failover?

• A.The system was administratively rebooted.
• B.The overdog process crashed.
• C.The process bcm56xxd received SIGTERM from the watchdog process.
• D.The configuration reload request caused the config to reload and the device to failover.

Comment: *

Name: *

Email: *

Verification: *

-- Exhibit -


-- Exhibit -
Refer to the exhibits.
After upgrading LTM from v10 to v11, users are unable to connect to an application. The virtual server is using a client SSL profile for re-terminating SSL for payload inspection, but a server SSL profile is being used to re-encrypt the request.
A client side ssldump did NOT show any differences between the traffic going directly to the server and the traffic being processed by the LTM device. However, packet capture was done on the server, and differences were noted.
Which modification will allow the LTM device to process the traffic correctly?

• A.Change Secure Renegotiation to "Request."
• B.Enable ProxySSL option in the server SSL profile.
• C.Change to different ciphers on the server SSL profile.
• D.Enable Strict Resume.

Comment: *

Name: *

Email: *

Verification: *

Which iRule will reject any connection originating from a 10.0.0.0/8 network?

• A.when CLIENT_ACCEPTED {
  set remote_ip [IP::addr [IP::remote_addr] mask 8]
  switch $remote_ip {
  "10.0.0.0" { reject }
  "11.0.0.0" { pool pool_http1}
  default { pool http_pool }
  }
  }
• B.when CLIENT_ACCEPTED {
  set remote_ip [IP::addr [IP::local_addr] mask 255.0.0.0]
  switch $remote_ip {
  "10.0.0.0" { reject }
  "11.0.0.0" { pool pool_http1}
  default { pool http_pool }
  }
  }
• C.when CLIENT_ACCEPTED {
  set remote_ip [IP::addr [IP::client_addr] mask 255.0.0.0]
  switch $remote_ip {
  "10.0.0.0" { reject }
  "11.0.0.0" { pool pool_http1}
  default { pool http_pool }
  }
  }
• D.when CLIENT_ACCEPTED {
  set remote_ip [IP::addr [IP::local_addr] mask 8]
  switch $remote_ip {
  "10.0.0.0" { reject }
  "11.0.0.0" { pool pool_http1}
  default { pool http_pool }
  }
  }

Comment: *

Name: *

Email: *

Verification: *

An LTM device pool has suddenly been marked down by a monitor. The pool consists of members 10.0.1.1:443 and 10.0.1.2:443 and are verified to be listening. The affected virtual server is 10.0.0.1:80.
Which two tools should the LTM Specialist use to troubleshoot the associated HTTPS pool monitor via the command line interface? (Choose two.)

• A.telnet
• B.curl
• C.ssldump
• D.tcpdump

Comment: *

Name: *

Email: *

Verification: *