A BIG-IP Administrator must determine if a Virtual Address is configured to fail over to the standby member of a device group in which area of the Configuration Utility can this be confirmed?

• A.Device Management > Devices
• B.Local Traffic > Virtual Servers
• C.Device Management > Traffic Groups
• D.Device Management > Overview

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The http monitor is applied to a pool. All members are enabled. One server responds as follows.

What is the resulting status of this poo! member?

• A.Offline (Disabled)
• B.Offline (Enabled)
• C.Unavailable (Disabled)
• D.Available (Enabled)

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator is working with a BIG-IP device and discovers that one of the Interfaces on a Trunk is DOWN.
What is the reason for this Interface status?

• A.The media speed of the interface has NOT been set
• B.There is NO default route configured for this trunk
• C.The switch is NOT connected to the Interface
• D.There is NO transceiver installed on the Interface

Comment: *

Name: *

Email: *

Verification: *

-- Exhibit -

-- Exhibit --
Refer to the exhibit.
An LTM Specialist configures a virtual server to perform client-side encryption while allowing the server-side traffic to be unencrypted. Application owners report that images are failing to load through the virtual server; however, images load when going directly to the server.
What is the problem with the images loading through the virtual server?

• A.The virtual server does not have an HTTP profile associated.
• B.Image references are for HTTPS objects, not HTTP.
• C.The virtual server does not have "SSL Offloading" enabled.
• D.Image references are for HTTP objects, not HTTPS.

Comment: *

Name: *

Email: *

Verification: *

An LTM Specialist must perform a packet capture on a virtual server with an applied standard FastL4 profile.
The virtual server 10.0.0.1:443 resides on vlan301.
Which steps should the LTM Specialist take to capture the data payload successfully while ensuring no other virtual servers are affected?

• A.The LTM device is under light load. The traffic should be mirrored to a dedicated sniffing device. On the sniffing device, the packet capture tcpdump -ni vlan301 should be executed.
• B.The packet capture tcpdump -ni vlan301 should be executed on the command line interface. There is no need to change profiles or PVA acceleration.
• C.The standard FastL4 profile should have PVA acceleration disabled. Then the packet capture tcpdump
  -ni vlan301 should be executed on the command line interface.
• D.A new FastL4 profile should be created and applied to the virtual server with PVA acceleration disabled.
  Then the packet capture tcpdump -ni vlan301 should be executed on the command line interface.

Comment: *

Name: *

Email: *

Verification: *