You are creating an LDP-signaled Layer 2 circuit between two sites. Site1 and Site2 use different VLAN IDs to connect to your PE devices In this scenario, which encapsulation type must be used on the logical interfaces?

• A.vlan-vpls
• B.vlan-tcc
• C.vlan-bridge
• D.vlan-ccc

Comment: *

Name: *

Email: *

Verification: *

Which two statements about IS-IS are correct? (Choose two.)

• A.An IS-IS router sets the attached bit in the PDUs it sends to a Level 1 area to indicate that it is a backbone router.
• B.Level 1 intermediate systems exchange routing information with Level 1 intermediate systems on other IS-IS areas.
• C.A Level 1 router can only form adjacencies with other Level 1 routers.
• D.Level 2 routers can form adjacencies with either Level 1 or Level 2 routers.

Comment: *

Name: *

Email: *

Verification: *

You recently deployed CoS-based forwarding in your network, which uses OSPF as its IGP You notice that the forwarding of traffic has not changed and is not following the path indicated within your configuration.
In this scenario, which statement explains this behavior?

• A.The defined policy has not been applied under [edit class-of-service forwarding-policy
• B.Load balancing has not been enabled under [edit forwarding-options.
• C.The defined policy references IP addresses as the next-hops instead of interface names
• D.The defined policy references interface names as the next-hops instead of IP addresses.

Comment: *

Name: *

Email: *

Verification: *

You want to allow the load balancing of traffic for an EBGP route from two different peers in the same AS.
Which three actions are needed to accomplish this task? (Choose three.)

• A.A policy to load-balance traffic should be applied to the forwarding table
• B.An equal cost AS path for the route is required.
• C.The multihop parameter should be configured under protocols BGP
• D.At least two interfaces should be connected to the same EBGP neighbor
• E.The multipath parameter should be configured under protocols BGP

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Referring to the exhibit, which two statements about route reflectors are correct? (Choose two.)

• A.RR2 advertises routes learned from Client3 to EBGP2 with itself as the next hop.
• B.RR1 advertises routes learned from Client1 to RR2 with itself as the next hop.
• C.RR2 adds its cluster ID when advertising routes from CHent4 to Client3.
• D.RR1 and RR2 need the same cluster ID to exchange routes learned from their clients.

Comment: *

Name: *

Email: *

Verification: *