Exhibit:

All adjacencies have been formed, no extra options have been configured, and no policies have been written.
Referring to the exhibit, which two statements are correct? (Choose two.)

• A.R2 will create a default route and send it as a TLV to R1
• B.R1 cannot reach R5
• C.R1 can reach R5.
• D.R1 will create its own default route that points to R2

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

Two CE devices (CE-1 and CE-2) belong to the same customer and connect into a single PE device (PE-1) However, the CE devices cannot communicate with each other You want to allow the CE devices to communicate with each other Referring to the exhibit, which action would solve the problem?

• A.Configure both routing instances with the vrf-table-label statement
• B.Configure both routing instances with the set routing-options autonomous-system loops 3 statement
• C.Configure both routing instances with the set routing-opt ions auto-export-statement
• D.Configure both routing instances with the as-override statement within the BGP protocol

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

The route shown in the exhibit is an example of which type of next-generation MVPN route?

• A.Type 4 Selective MVPN autodiscovery route for leaf
• B.Type 3 Selective MVPN autodiscovery route
• C.Type 2 Inter-AS inclusive MVPN membership discovery
• D.Type 1 Intra-AS inclusive MVPN membership discovery

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Referring to the exhibit, a Layer 3 VPN is configured, however, the routes are being hidden.
What is the problem?

• A.An active MPLS tunnel does not exist between the peers.
• B.A VRF target community mismatch exists between the peers.
• C.The BGP peer is not reachable through the IGP.
• D.A route distinguisher mismatch exists between the peers.

Comment: *

Name: *

Email: *

Verification: *

The link between CE1 and PE1 has a history of flapping To avoid the impact that flapping causes to the network you decide to use route damping Which statement is correct in this scenario?

• A.Dampened routes become active when their figure of merit drops below the reuse value.
• B.Routes become dampened when the configured max-suppress value is reached
• C.Dampening is enabled on interfaces
• D.Dampened routes decay at a sliding rate known as half-life

Comment: *

Name: *

Email: *

Verification: *