Exhibit:

Referring to the exhibit, you want to make ISP1 your preferred connection for inbound and outbound traffic.
Which two steps will accomplish this task? (Choose two.)

• A.Create an export policy setting local-preference 200 and next-hop self and apply it to the IBGP peers on R1.
• B.Create an export policy to prepend the ASN on advertised routes and apply it to the EBGP peer on R1.
• C.Create an export policy setting local-preference 200 and next-hop self and apply it to the IBGP peers on R2.
• D.Create an export policy to prepend the ASN on advertised routes and apply it to the EBGP peer on R2.

Comment: *

Name: *

Email: *

Verification: *

Your router should be configured with a rewrite rule which alters the default behavior of expedited forwarding as shown in the exhibit.
In this scenario, which configuration is correct?

• A.
• B.
• C.
• D.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

A network administrator is migrating from IPv4 to IPv6 and one of the IS-IS adjacencies is not coming up between R1 and R2.
Which action will solve the problem?

• A.Remove topologies ipv6-unicast from protocols isis on R2.
• B.Configure topologies ipv4-unicast from protocols isis on R2.
• C.Configure an IPv4 address on interface ge-0/0/1 on R1.
• D.Remove topologies ipv6-unicast from protocols isis on R1.

Comment: *

Name: *

Email: *

Verification: *

A network administrator is migrating from IPv4 to IPv6 and one of the IS-IS adjacencies is not coming up between R1 and R2.
Which action will solve the problem?

• A.Remove topologies ipv6-unicastfrom protocols isison R1.
• B.Configure topologies ipv4-unicastfrom protocols isison R2.
• C.Configure an IPv4 address on interface ge-0/0/1on R1.
• D.Remove topologies ipv6-unicastfrom protocols isison R2.

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, there is a Layer 3 VPN setup that connects sites CE-A-1, CE-A-2, and CE-A-3 together. Host-1 can communicate with Host-3, but Host-1 cannot communicate with Host-2.
What must you do to solve the problem?

• A.Change the route distinguisher in both routing instances to the same value.
• B.Use the auto-exportcommand in both routing instances.
• C.Use BGP instead of static routing between the CE and PE devices.
• D.Use the next-tableconfiguration statement for static routes in the corresponding routing instances.

Comment: *

Name: *

Email: *

Verification: *