Which two statements about virtual links are correct? (Choose two.)

• A.Virtual links are bidirectional.
• B.Virtual links are used for control plane traffic.
• C.Virtual links are point-to-point.
• D.Virtual links are excluded from SPF calculations.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

The route shown in the exhibit is an example of which type of next-generation MVPN route?

• A.Type 2 Inter-AS inclusive MVPN membership discovery
• B.Type 3 Selective MVPN autodiscovery route
• C.Type 1 Intra-AS inclusive MVPN membership discovery
• D.Type 4 Selective MVPN autodiscovery route for leaf

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

You are the administrator of AS 65512 You are learning the 192 168 1 0/24 prefix from both AS 100 and AS
200 You want traffic destined to the 192 168 1.0.0/24 prefix to exit your AS towards AS 200 How would you accomplish this task'?

• A.Configure an import routing policy on PE-2 to append the AS path attribute on the path learned from AS
  100
• B.Configure an import routing policy on PE-2 to modify the origin attribute on the path learned from AS
  100
• C.Configure an import routing policy on PE-2 to set a higher local preference value on the path learned from AS 200
• D.Configure an import routing policy on PE-2 to set a higher MED on the path learned from AS 100

Comment: *

Name: *

Email: *

Verification: *

Which two statements regarding Ethernet segments (ES) are correct? (Choose two.)

• A.The Type-3 EVPN route will be used for the aliasing function to load-balance to the ES.
• B.The Type-1 EVPN route will indicate if the ES is all-active or single-active.
• C.The Type-4 EVPN route will be used to elect the designated forwarder for the ES.
• D.The Type-2 EVPN route will indicate if there is a designated forwarder on the ES.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

You have an established Layer 3 VPN between two PE devices. You are asked to only send certain routes from PE-1 over the VPN to the remote site while maintaining all the routes on the PE-1 device. You created a policy that matches the specific routes and then tags these routes with the appropriate target community values.
In this scenario, which configuration changes must be made to satisfy the requirement?

• A.Configure a RIB group and apply the policy as an import policy to routes distributed into the bgp I3vpn.0 routing table
• B.Configure the import parameter and apply the policy to the my-ext-group BGP group configuration.
• C.Configure the export parameter and apply the policy to the my-ext-group BGP group configuration.
• D.Configure the vrf-export parameter and apply the policy under the edit routing-instances vpn-a hierarchy.

Comment: *

Name: *

Email: *

Verification: *