You are provisioning Layer 2 circuits between sites CE1, CE2, and CE3.
Referring to the exhibit, which statement is true?

• A.Each site must have only one VLAN configured to the PE.
• B.Site PE1 must have a point-to-multipoint link configured towards the core.
• C.Two VLANs must be configured from PE 1 to CE 1.
• D.A point-to-multipoint LSP must be created between sites.

Comment: *

Name: *

Email: *

Verification: *

Which statement is correct about BGP FlowSpec between a service provider's PE router and a customer?

• A.The flow routes received from a customer are limited to /32 masks for IPv4.
• B.The RFC deterministic traffic filtering algorithm is used by default in Junos.
• C.The NLRI received from a customer is stored in the flowspec. inet .0 table.
• D.The NLRI received from a customer is stored in the inetfiow.0 table

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Referring to the exhibit, external routes are being received at R1. These routes must appear on R5.
Which action will produce this result?

• A.Write an export policy on R4 from level 2 to level 1 matching the external routes.
• B.Write an export policy on R2 from level 1 to level 2 matching the external routes.
• C.Turn on wide metrics on R4 and R5 and write an export policy on R2 from level 1 to level 2 matching the external routes.
• D.Turn on wide metrics on R1 and R2 and write an export policy on R4 from level 2 to level 1 matching the external routes.

Comment: *

Name: *

Email: *

Verification: *

You want to allow the load balancing of traffic for an EBGP route from two different peers in the same AS.
Which three actions are needed to accomplish this task? (Choose three.)

• A.The multipath parameter should be configured under protocols BGP
• B.At least two interfaces should be connected to the same EBGP neighbor
• C.A policy to load-balance traffic should be applied to the forwarding table
• D.An equal cost AS path for the route is required.
• E.The multihop parameter should be configured under protocols BGP

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

You are troubleshooting BGP routing issues between two MX Series routers. The BGP session is established but no BGP routes are being communicated.
What are two reasons for this problem? (Choose two.)

• A.The peers are in different ASs.
• B.table ii No export routing policy is applied.
• C.No active BGP routes are in the inet.0 table
• D.The peer type should be external.

Comment: *

Name: *

Email: *

Verification: *