Exhibit.

You manage an MX Series device which includes the configuration shown in the exhibit Traffic marked with DSCP 000011 is entering the ge-1/0'4 interface at 102 Mbps The traffic exits the device on the ge-1 '0/5 interface No other traffic is transiting the router In this scenario what happens to traffic exceeding 100 Mbps?

• A.Traffic exceeding 100 Mbps is dropped
• B.Traffic exceeding 100 Mbps is redirected to a rate limiter.
• C.Traffic exceeding 100 Mbps is forwarded.
• D.Traffic exceeding 100 Mbps Is buffered

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

R2 is receiving a route from R1 and you must ensure that the route is not advertised to R3.
Referring to the exhibit, which two configurations on R2 will solve the issue? (Choose two.)

• A.Apply the no-export policy as an export policy under group 65003
• B.Apply the no-export policy as an import policy under group 65001
• C.Apply the no-advertise policy as an import policy under group G5001
• D.Apply the no-advertise policy as an export policy under group 65003

Comment: *

Name: *

Email: *

Verification: *

Which two statements are true about what a route reflector does by default when distributing routes it has received from reflector clients? (Choose two.)

• A.It adds its cluster ID to the client-received routes.
• B.It changes the default BGP attributes to inform peers that it is a route reflector.
• C.It does not change any received BGP attributes.
• D.It sets the next hop of all routes to "self' to prevent routing loops.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)

• A.Apply the prepend policy as an import policy under group R1.
• B.Configure multipath under the global BGP configuration.
• C.Configure multipath under group R1.
• D.Apply the prepend policy as an import policy under group R3.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

The exhibit shows a BGP peering session for two PE routers. The BGP session is up, but the hosts in the Layer
2 VPN that uses the BGP session are unable to communicate.
What is the problem in this situation?

• A.The local BGP router does not support Layer 2 VPN and Layer 3 VPN NLRI address families at the same time.
• B.There is a mismatch in the supported NLRI address families between the BGP peers.
• C.The BGP peer does not support the restarter functionality.
• D.The BGP peer does not support the add-path feature.

Comment: *

Name: *

Email: *

Verification: *