Click on the exhibit.

Given the output shown, which router is the ASBR in this network?

• A.10.10.10.3
• B.10.10.10.2
• C.10.10.10.4
• D.There is no ASBR configured in the network.
• E.10.10.10.6

Comment: *

Name: *

Email: *

Verification: *

Which of the following describes the purpose over4 tunneling?

• A.To allow IPv6 traffic to pass through an IPv4 network.
• B.To give IPv4 only routers the ability to route based on IPv6 addresses.
• C.To allow core routers running only IPv6 protocols to carry IPv4 traffic.
• D.To give IPv6 traffic preferential routing over IPv4 routes.

Comment: *

Name: *

Email: *

Verification: *

When IS-IS is electing a DIS, what is used as the tie breaker on an Alcatel-Lucent 7750 SR, if the priorities are the same?

• A.The highest interface MAC address
• B.The system ID
• C.The device that first initiated communication becomes the DIS
• D.The sequence number of the Hello packet
• E.The loopback address

Comment: *

Name: *

Email: *

Verification: *

Which of the following statements regarding the last two octets of the LDP identifier is true?

• A.It is always zero for per-platform label space.
• B.It is always non-zero.
• C.It is always a random 16-bit number.
• D.It is always non-zero for per-platform label space.
• E.It is always zero for per-interface label space.

Comment: *

Name: *

Email: *

Verification: *

Which of the following about T-LDP on the Alcatel-Lucent 7750 SR is FALSE?

• A.T-LDP is used in LDP over RSVP solution.
• B.T-LDP is used to provide an end-to-end session between two PE routers.
• C.T-LDP is used to establish transport tunnels for Layer 2 services.
• D.T-LDP is used to signal service labels for Layer 2 services.

Comment: *

Name: *

Email: *

Verification: *