Click on the exhibit.

Which of the following is FALSE?

• A.The router can reach the far-end of the LSP through an LDP tunnel.
• B.The Isp-ping tool is used to perform a unidirectional LSP test.
• C.The router 10.10.10.2 is the egress router of the LSP.
• D.The router can reach the far-end of the LSP through an RSVP-TE tunnel.

Comment: *

Name: *

Email: *

Verification: *

An Alcatel-Lucent 7750 SR has a port with the MAC address of 00;03:FA:AC:77: AF. The port is bound to an interface.
If IPv6 is then enabled on that interface .what will the link-local address be?

• A.FC00::203:FAFF:FEAC:77AF/64
• B.FE80::3FAFF:FEAC:77AF/64
• C.FC00::3:FAFF:FEAC:77AF/64
• D.2000::203:FAFFFEAC:77AF/64
• E.FE80::203:FAFF:FEAC:77AF/64

Comment: *

Name: *

Email: *

Verification: *

Which of the following about an LSP protected with one-to-one FRR is TRUE?

• A.A detour protection tunnel is created for the LSP.
• B.A single protection tunnel is used for all LSPs with the same path.
• C.The LSP is limited to node protection.
• D.The LSP can use facility and one-to-one FRR simultaneously.

Comment: *

Name: *

Email: *

Verification: *

Which of the following about CAC is FALSE?

• A.CAC is used to perform a bandwidth check based on the router's LSDB.
• B.CAC is used to perform a bandwidth check on each egress interface of the downstream router.
• C.CAC is used when the LSP path has not been computed by CSPF.
• D.CAC is used when the LSP path has been computed by CSPF.

Comment: *

Name: *

Email: *

Verification: *

Click on the exhibit.

Router R1 learns the network 192.168.3.0/24 from IS-IS.
Given the OSPF configuration shown, why isn't the 192.168.3.0/24 route in router R3's route table?

• A.The route policy should say "from protocol isis" instead of "from protocol direct".
• B.The interface between routers R1 and R3 must be in OSPF area 0.
• C.The route policy should be applied as an import policy.
• D.The ASBR configuration should be removed.

Comment: *

Name: *

Email: *

Verification: *