Which tool identifies the point of failure in a P2MP LSP from the ingress LSR?

• A.Jitter TLV
• B.SPAN
• C.P2MP traceroute
• D.P2MP ping

Comment: *

Name: *

Email: *

Verification: *

Which optional information can be included with an IPv6 ping to support the troubleshooting process?

• A.IPv4 IP address
• B.source MAC address
• C.destination MAC address
• D.IPv6 hostname

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)

• A.CE1 must use OSPF to establish a neighbor relationship with PE1.
• B.PE1 labels the routes it learns from CE1 with the route-target 222:2 and shares them with its VPNv4 peers.
• C.PE1 labels the routes it learns from CE1 with the route-target 111:1 and shares them with its VPNv4 peers.
• D.The PE-CE routes between the devices are being exchanged by OSPF
• E.CE1 is supporting CSC.

Comment: *

Name: *

Email: *

Verification: *

In Layer 3 MPLS VPN implementations, if some of the VPNv4 routes on one PE router do not appear on another PE router, what could be the problem?

• A.VRF name mismatch between the PE routers
• B.RT export and import configuration errors
• C.RD export and import configuration errors
• D.RD mismatch between the PE routers

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

• A.In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
• B.OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0
• C.IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway
• D.OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

Comment: *

Name: *

Email: *

Verification: *