You try to configure MPLS VPN VRF Selection based on a source IP address on an interface that has VRF configured, but you receive an error.
Which action must you take to correct the problem?

• A.Change the source IP address.
• B.Add the IP address to the VRF table.
• C.Remove the VRF from the interface.
• D.Configure static routes for the VRF.

Comment: *

Name: *

Email: *

Verification: *

Which two differences must an engineer consider when choosing between Layer 2 and Layer 3 VPNs? (Choose two.)

• A.VPWS is a Layer 2 VPN and VLL in SVC mode is a Layer 3 VPN.
• B.VPLS is a Layer 2 VPN and MPLS/BGP VPN is a Layer 3 VPN.
• C.MPLS is a Layer 2 VPN and Frame Relay is a Layer 3 VPN.
• D.E-VPN is a Layer 2 VPN and IPsec is a Layer 3 VPN.
• E.DMVPN is a Layer 2 VPN and VPLS is a Layer 3 VPN.

Comment: *

Name: *

Email: *

Verification: *

In Layer 3 MPLS VPN implementations, if some of the VPNv4 routes on one PE router do not appear on another PE router, what could be the problem?

• A.RD mismatch between the PE routers
• B.RT export and import configuration errors
• C.VRF name mismatch between the PE routers
• D.RD export and import configuration errors

Comment: *

Name: *

Email: *

Verification: *

Which statement describes the result of this BGP configuration?

• A.R1 establishes an iBGP relationship with peer 192.168.1.1.
• B.R1 operates using IPv4 and VPNv4 address families.
• C.R1 establishes a VPNv4 eBGP relationship with neighbor 192.168.1.1.
• D.R1 operates on IPv6 only because the bgp default ipv4-unicast command is missing.

Comment: *

Name: *

Email: *

Verification: *

Which two frames can be configured on an Ethernet flow point? (Choose two.)

• A.of a specific VLAN
• B.with different type of service values
• C.with identical type of service value
• D.with different class of service values
• E.with no tags

Comment: *

Name: *

Email: *

Verification: *