A Fibre Channel interface on a Cisco Nexus 5000 Series Switch receives bit errors, and the switch disables the interface. A temporary workaround must be implemented before the root cause is identified. Which action does an engineer take to prevent this issue from reoccurring?

• A.Verify that the SFPs are supported.
• B.Change the SFP to operate at 4 Gbps instead of 2 Gbps.
• C.Run the shutdown and then no shutdown command on the interface.
• D.Run the switchport ignore bit-errors command on the interface.

Comment: *

Name: *

Email: *

Verification: *

An engineer attempts to register Cisco UCS Manager to Cisco UCS Central, but the registration fails. The engineer can ping Cisco UCS Central from UCS Manager. Which two actions must the engineer attempt to resolve the problem? (Choose two.)

• A.Synchronize the date and time to NTP for Cisco UCS Central and the Cisco UCS domains.
• B.Apply the UCS Central license to UCS Central.
• C.Place Cisco UCS Manager on the same subnet as Cisco UCS Central.
• D.Allow port 443 between Cisco UCS Manager and Cisco UCS Central.
• E.Allow port 9443 between Cisco UCS Manager and Cisco UCS Central.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The initiator that has FC ID 0x970102 fails to communicate with the target that has FC ID 0x970200. What action resolves the issue?

• A.Reactivate the zoneset.
• B.Reset the port for FC ID 0x970102 and FC ID 0x970200 to log in to the fabric.
• C.Reset the port for FC ID 0x970209 and FC ID 0x9700c2 to log in to the fabric.
• D.Reconfigure the initiator and the target to be in the same zones.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The script fails to bring up Ethernet 1/2 when Ethernet 1/1 goes down. Which change enables the script to run as intended?

• A.Add an action to configure the terminal
• B.Set the port VLAN
• C.Configure an enable action
• D.Include an action to manually shut down Ethernet 1/1

Comment: *

Name: *

Email: *

Verification: *

A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?

• A.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
  2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
  3) Check for runtime link down status
  4) Reseat the affected IOM.
• B.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
  2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
  3) Check for runtime link down status
  4) Reseat the affected IOM.
• C.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
  2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
  3) Check for runtime link down status.
  4) Reseat the affected IOM.
• D.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
  2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
  3) Check for runtime link down status.
  4) Reseat the affected IOM.

Correct Answer: B

Explanation
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ts/guide/UCSTroubleshooting/UCSTroubleshooti

Comment: *

Name: *

Email: *

Verification: *