Refer to the exhibit. A web browser displays a "not secure" warning message when accessing the web interface of Cisco UCS Manager. Which action resolves the issue?

• A.Load third-party certificate to UCS Manager.
• B.Use the correct TCP port for HTTPS.
• C.Use a supported web browser.
• D.Use a supported version of UCS Manager.

Comment: *

Name: *

Email: *

Verification: *

During a boot process of a Cisco UCS C-Series Rack Server, an engineer receives a "No Signal" message from the vKVM and physical connection. Which set of steps resolves the issue?

• A.1- Disconnect the power cord
  2- Confirm that all cards are property seated
  3- Connect the power cord and power on the server
• B.1- Power off the server and disconnect the power cord
  2- Confirm that all cards are property seated
  3- Connect the power cord and power on the server
• C.1- Power off the server and disconnect the power cord
  2- Confirm that all cards are available
  3- Connect the power cord and power on the server
• D.1- Disconnect the power cord
  2- Confirm that all cards are properly seated
  3- Connect the power cord

Correct Answer: B

Explanation
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/ts/guide/b_C-Series_Troubleshooting_Guide.pd

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is configuring boot from iSCSI on a Cisco UCS B-Series Blade Server, but the LUN fails to mount. Which action resolves the issue?

• A.Set a connection timeout value of 250 in the iSCSI Adapter Policy.
• B.Configure an MTU size of 9000 on the appliance port.
• C.Statically configure the target information in the Boot Policy.
• D.Configure a QoS policy on the vNIC.

Comment: *

Name: *

Email: *

Verification: *

One of Cisco Nexus Series interfaces has become errdisabled with the error message "DCX-No ACK in 100 PDUs". What is the cause of this error?

• A.The acknowledgement number in the server response has not incremented for 100 exchanges.
• B.Cisco Discovery Protocol is disabled on the switch.
• C.LLDP is disabled on the switch.
• D.The host has not responded to the Control Sub-TLV DCBX exchanges of the switch.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The HSRP configuration in the exhibit fails to function. Which action resolves this issue?

• A.Configure HSRP version 2.
• B.Set the MTU to 1500 bytes.
• C.Configure the same HSRP group on both devices.
• D.Enable IP redirects.

Comment: *

Name: *

Email: *

Verification: *