After the photoconductor has been cleaned, the next step of the process is to:

• A.charge to entire photoconductor surface with an even charge.
• B.transfer a developed image to the media.
• C.develop an image on the photoconductor in the charged area.
• D.write the image on the photoconductor using a laser/LED.

Comment: *

Name: *

Email: *

Verification: *

During the photoconductor preparation step, residual charge can be removed by which of the following? (Select TWO).

• A.Pressure
• B.Light
• C.Oil
• D.Gravity
• E.Electrical Charge

Comment: *

Name: *

Email: *

Verification: *

Which of the following is an example of a physical port that can be used to connect a device?

• A.TCP/IP
• B.LPR
• C.SCSI
• D.Port 9100

Comment: *

Name: *

Email: *

Verification: *

When scanning to a network folder, a technician receives an error message indicating the scan was unsuccessful. Which of the following could be the MOST likely cause of the error?

• A.Scanning is not enabled on the MFP
• B.TWAIN driver is not installed
• C.Incorrect LDAP server settings
• D.Permissions for the folder are not set

Comment: *

Name: *

Email: *

Verification: *

A customer wants to turn off their network printer when leaving the office to save energy. To avoid communication problems after the customer turns the printer on, which of the following solutions should the technician recommend?

• A.Switch to a USB connection
• B.Enable SNMP
• C.Enable DHCP
• D.Configure a static IP address

Comment: *

Name: *

Email: *

Verification: *