Which LSA type provides information necessary to reach routers originating type 5 LSA's in other areas?

• A.ASBR-Summary (Type 4)
• B.NSSA (Type 7)
• C.Summary (Type 3)
• D.Router (Type 1)

Comment: *

Name: *

Email: *

Verification: *

What is a valid OS10 iBGP configuration?

• A.S2(config)# router bgp 64507
  S2(config-router-bgp-64507)# peer-as 64507
  S2(config-router-bgp-64507)# neighbor 192.168.32.1 S2(config-router-neighbor)# update-source loopback 0 S2(config-router-neighbor)# no shutdown
• B.S2(config)# router bgp 64507
  S2(config-router-bgp-64507)# neighbor 192.168.32.1
  S2(config-router-bgp-64507)# remote-as 64507 S2(config-router-bgp-64507)# update-source loopback 0 S2(config-router-bgp-64507)# no shutdown
• C.S2(config)# router bgp 64507
  S2(config-router-bgp-64507)# neighbor 192.168.32.1
  S2(config-router-neighbor)# remote-as 64507 S2(config-router-neighbor)# update-source loopback 0 S2(config-router-neighbor)# no shutdown
• D.S2(config)# router bgp 64507
  S2(config-router-bgp-64507)# remote-as 64507
  S2(config-router-bgp-64507)# neighbor 192.168.32.1 S2(config-router-neighbor)# update-source loopback 0 S2(config-router-neighbor)# no shutdown

Comment: *

Name: *

Email: *

Verification: *

In a PIM Sparse Mode (PIM-SM) based multicast topology, what function does the Rendezvous Point provide?

• A.The node is used to provide IGMP snooping on a layer 2 shared segment.
• B.The root node of the shared tree topology is used to provide routing between the source and receiver.
• C.The root node of the source tree topology is used to provide routing between the source and receiver.
• D.The node is used to provide IGMP snooping across a layer 3 boundary.

Comment: *

Name: *

Email: *

Verification: *

Which command shows whether a LAG protocol is static or dynamic on a Dell EMC Networking OS10 switch?

• A.show lacp neighbor
• B.show running-configuration lacp
• C.show interface port-channel summary
• D.show port-channel summary

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.
Which configuration will allow S1 to ping S2's Lo0 address?

• A.S1(config-router)# ip route 192.168.32.2 144.254.32.1/32
• B.S1(config)# ip route 144.254.32.1/32 192.168.32.2
• C.S1(config-router)# ip route 144.254.32.1 192.168.32.2/32
• D.S1(config)# ip route 192.168.32.2 144.254.32.1/32

Comment: *

Name: *

Email: *

Verification: *