-- Exhibit-

-- Exhibit -
Refer to the exhibits.
An LTM Specialist uses the information in the logs to determine the cause of a failover event in a high-availability (HA) pair.
What caused the failover?

• A.The process bcm56xxd received SIGTERM from the watchdog process.
• B.The overdog process crashed.
• C.The system was administratively rebooted.
• D.The configuration reload request caused the config to reload and the device to failover.

Comment: *

Name: *

Email: *

Verification: *

An LTM Specialist configures two LTM devices in a high-availability pair with trusts established and device groups configured properly using network failover. After several months, the LTM Specialist notices that changes made to one LTM device do NOT cause the synchronization status to update to "changes pending," and this device does NOT synchronize with the device group.
Which two steps should the LTM Specialist take to identify the issue? (Choose two.)

• A.Verify that the devices are not using self-signed certificates.
• B.Verify that port lockdown on the ConfigSync interface is set to allow port 1026.
• C.Verify the network connectivity between the devices.
• D.Verify that NTP is synchronized.
• E.Verify that ConfigSync is using the management IP address.

Comment: *

Name: *

Email: *

Verification: *

-- Exhibit - -- Exhibit -


Refer to the exhibits.
A customer requests to offload SSL for an internal website. The front page of the website loads correctly; however, selecting links on the page fails.
How should the LTM Specialist fix the issue?

• A.Create a new Server SSL profile.
  Enable Proxy SSL.
  Add the Server SSL profile to the VS.
• B.Create a new SNAT pool.
  Add internal network IPs to the SNAT pool.
  Add the SNAT pool to the VS.
• C.Create a new HTTP profile.
  Enable redirect rewrite.
  Add the new HTTP profile to the VS.
• D.Create a new HTTP profile.
  Enable Insert X-Forwarded-For.
  Add the new HTTP profile to the VS.

Comment: *

Name: *

Email: *

Verification: *

A high-availability (HA) pair configuration uses only the hardwire serial cable connection to determine device state. A power outage occurs to the PDU powering the active unit. The standby unit takes over the active role as expected.
How is the peer unit able to determine the active unit is unavailable?

• A.no heartbeat packets received on self IPs
• B.no data stream received on serial port
• C.voltage loss on serial cable
• D.no response on management interface

Comment: *

Name: *

Email: *

Verification: *

An FTP monitor is NOT working correctly.
Which three pieces of information does the LTM Specialist need to provide to ensure a properly working FTP monitor? (Choose three.)

• A.alias
• B.username
• C.FTP server port
• D.password
• E.File path
• F.FTP server IP address

Comment: *

Name: *

Email: *

Verification: *