In the network shown in the figure, the correct description of the following is:

• A.The network between SWA and SWB is the same broadcast domain.
• B.The network between SWA and SWC is the same broadcast domain.
• C.The network between RTA and SWC is the same collision domain.
• D.The network between SWA and SWC is the same collision domain.

Comment: *

Name: *

Email: *

Verification: *

In the MAC address table of SWA and SWB, is the MAC address, VLAN and port correspondence correct?

• A.SWB: ---------------------------------------------------------------------------- MAC Address VLAN Port ----------------------------------------------------------------------------- MAC-A 10 GEO/0/3 MAC-B 20 GEO/0/3 MAC-C 100 GEO/0/1
• B.SWA: ---------------------------------------------------------------------------- MAC Address VLAN Port ----------------------------------------------------------------------------- MAC-A 10 GEO/0/1 MAC-B 20 GEO/0/2 MAC-C 100 GEO/0/3
• C.SWA: ---------------------------------------------------------------------------- MAC Address VLAN Port ----------------------------------------------------------------------------- MAC-A 10 GEO/0/3 MAC-B 20 GEO/0/3 MAC-C 100 GEO/0/3
• D.SWB: ---------------------------------------------------------------------------- MAC Address VLAN Port ----------------------------------------------------------------------------- MAC-A 10 GEO/0/3 MAC-B 20 GEO/0/3 MAC-C 100 GEO/0/1

Comment: *

Name: *

Email: *

Verification: *

Which of the following statements about link aggregation is correct? (Muitiple choice)

• A.Eth-Truk interfaces cannot be nested
• B.The GE interface and the FE interface cannot be added to the same Eth-Trunk interface.
• C.GE electrical interfaces and GE optical interfaces cannot be added to the same Eth-Trunk interface.
• D.Ensure that the modes of link aggregation on the two devices are the same when the two devices are connected to each other.

Comment: *

Name: *

Email: *

Verification: *

In the network shown below, which of the following commands can be entered in the router to enable Host A to ping through Host B? (Multiple Choice)

• A.Router A : ip route-static 10.0.12.5 255.255.255.252 11.0.12.2 Router B : ip route-static 10.0.12.1 255.255.255.252 11.0.12.1
• B.Router A : ip route-static 0.0.0.0 0.0.0 11.0.12.2 Router B : ip route-static 0.0.0.0 0.0.0 11.0.12.1
• C.Router A : ip route-static 0.0.0.0 0.0.0 11.0.12.1 Router B : ip route-static 0.0.0.0 0.0.0 11.0.12.2
• D.Router A : ip route-static 10.0.12.5 255.255.255.252 11.0.12.1 Router B : ip route-static 10.0.12.1 255.255.255.252 11.0.12.2

Comment: *

Name: *

Email: *

Verification: *

Which of the following network types does OSPF support? (Multiple Choice)

• A.Non-Broadcast Multi-Access.
• B.Point-to-Point.
• C.Point-to-Multipoint.
• D.Broadcast.

Comment: *

Name: *

Email: *

Verification: *