Refer to the exhibit.

A network engineer is implementing a pair of Cisco Nexus 9000 Series Switches. During the OSPF configuration, the engineer discovers unstable routing in the network. The investigation shows flapping routes after the new switches were introduced. Which set of actions resolves the issue?

• A.Configure a new OSPF priority on the Ethernet interface toward the OSPF neighbor. Clear the OSPF neighbor.
• B.Configure a new IP address on the Ethernet interface toward the OSPF neighbor. Clear the OSPF neighbor.
• C.Configure a new IP address on the Loopback interface for the OSPF process. Clear the OSPF process
• D.Configure a new IP address on the Ethernet interface toward the OSPF neighbor. Clear the OSPF process.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. When an engineer inserts 8-Gb FC SFP port 15 on a Cisco UCS Fabric Interconnect, the port fails. What is a possible cause of the issue?

• A.Port 15 is configured as an Ethernet port.
• B.Port 15 is configured for 4-Gb FC.
• C.Port 15 is missing a license.
• D.The polarity of the fiber cable is reversed.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The EEM script fails to send an SNMP trap when a user attempts to enter configuration mode. Which configuration is missing from the script?

• A.policy-default action statement
• B.IP address of the SNMP server
• C.event statement
• D.event-default action statement

Comment: *

Name: *

Email: *

Verification: *

A Cisco UCS B-Series Blade Server is configured to boot a VMware ESXi host from an EMC VNX storage array by using a Fibre Channel SAN. The boot order is confirmed to be configured as expected, but the server fails to boot from the SAN. Which action resolves the problem?

• A.Set the boot LUN to the highest LUN ID in the storage array.
• B.Set the boot LUN to the lowest LUN ID in the storage array.
• C.Set the same WWNN pools for vHBA adapters.
• D.Set the same WWPN pools for vHBA adapters.

Comment: *

Name: *

Email: *

Verification: *

A Cisco UCSB-Series Blade Server is configured to boot a VMwareESXi host from an EMC VNX storage array by using a Fibre Channel SAN. The boot order is confirmed to be configured as expected but the server fails to boot from the SAN. Which action reserves the problem?

• A.Set the same WWNN pools for vHBA adaptor
• B.Set the boot LUN to the lowest LUN ID in the storage array
• C.Set the same WWPN pools for vHBA adapters
• D.Set the boot LUN to the highest LUN ID in the storage array

Comment: *

Name: *

Email: *

Verification: *