An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer monitors a Cisco UCS server logs and discovers a blade discovery issue. Which procedure resolves the issue?

• A.1. Verify the server power module.
  2. Decommission the faulty module.
  3. Insert a new power module.
  4. Recommission the new module.
• B.1. Verify that the power on self-test operation is failed.
  2. Verify that the server firmware is corrupted.
  3. Decommission the server firmware
  4. Recommission the server with new firmware.
• C.1. Verify the FSM status on the server.
  2. Decommission the impacted server.
  3. Reset the slot where the server is located.
  4. Recommission the server.
• D.1. Verify that server platform power is failed
  2. Resolve the platform power issue.
  3. Reboot the server.
  4. Recommission the server.

Comment: *

Name: *

Email: *

Verification: *

Cisco Unified Computing System Manager raises a critical error message that indicates that the system has overlapping Ethernet and FCoE VLANs. All of the Ethernet traffic on the overlapping VLANs drops.
Which action resolves the issue?

• A.Modify the VLAN assignment to vNICs.
• B.Change the PIN groups on the vHBAs.
• C.Modify the FCoE VLAN.
• D.Set the FCoE VLAN as the native VLAN on server uplinks.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer discovered a VFC interface in a down state on a Cisco Nexus Switch. Which action resolves the problem?

• A.Modify the fip keepalive message time to 30 seconds
• B.Change the cable between the switch and the server
• C.Reset the Cisco Nexus port toward the file server
• D.Update the CNA firmware and driver versions

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.
The FCoE traffic fails to traverse the vfc2 interface. The VSAN 102 is configured for vfc2. Which action resolves the issue?

• A.Enable LLDP on the neighbor switch
• B.Enable LLDP on the interface vfc2
• C.Activate DCBX on the interface e101/1/2
• D.Activate DCBX on the N9K switch

Comment: *

Name: *

Email: *

Verification: *