Refer to the exhibit.

The HSRP configuration in the exhibit fails to function. Which action resolves this issue?

• A.Configure the same HSRP group on both devices.
• B.Configure HSRP version 2.
• C.Set the MTU to 1500 bytes.
• D.Enable IP redirects.

Comment: *

Name: *

Email: *

Verification: *

A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?

• A.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
  2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
  3) Check for runtime link down status
  4) Reseat the affected IOM.
• B.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
  2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
  3) Check for runtime link down status
  4) Reseat the affected IOM.
• C.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
  2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
  3) Check for runtime link down status.
  4) Reseat the affected IOM.
• D.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
  2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
  3) Check for runtime link down status.
  4) Reseat the affected IOM.

Correct Answer: B

Explanation
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ts/guide/UCSTroubleshooting/UCSTroubleshooti

Comment: *

Name: *

Email: *

Verification: *

A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)

• A.Configure the same VNI to multicast group maping.
• B.Set a different distributed gateway virtual MAC address.
• C.Set a different secondary IP addresses on NVE source-interface.
• D.Set a different primary IP addresses on NVE source-interface.
• E.Configure the NVE interfaces to be Up on both switches.

Comment: *

Name: *

Email: *

Verification: *

A network engineer experiences the error "DDR3_P1_B1_ECC" when upgrading Cisco UCS firmware.
Which action resolves the issue?

• A.Reset the BMC firmware
• B.Reflash the controller firmware
• C.Reflash the DIMM
• D.Reset the DIMM

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A switch is being downgraded to an earlier release because of a problem with the current release. After the switch is downgraded, it can no longer forward traffic. Which action resolves the issue?

• A.Roll back to the original image.
• B.Shut and no shut the interfaces to the FEX.
• C.Reload the switch.
• D.Enable ISSD after the downgrade is complete.

Comment: *

Name: *

Email: *

Verification: *